OFF GRID SOLAR INVERTER€¦ · OFF GRID SOLAR INVERTER KEY FEATURES High frequency pure sine wave design Multi-functional inverter- charger with programmable menus Inverter + 60A

OFF GRID SOLAR INVERTER

KEY FEATURES

● High frequency pure sinewave design

● Multi-functional inverter-charger with programmablemenus

● Inverter + 60A AC Charger +50A Solar Charger

● Total system charging : 50A +60A = 110A !!

● Adjustable Bulk/Float Voltand charging current

● Wide AC input range

● Lightweight, easy to install

● 2X surge capacity max 5s

● FREE monitoring software

● LCD Display + LED indicators

● Support main battery typese.g. Lead Acid, LiFePO4*

● Built-in genset starter drycontact**

● USB communication interface

PIP-HS series 812 1624 2424 3248 4048 1212 (1224)

ELECTRICAL SPECIFICATIONS

Continuous Output 800W 1600W 2400W 3200W 4000W 1200W

Surge Rating 5 seconds max, 2X

Input Power Factor 0.8

Input Voltage Range 90~280VAC (Appliance mode), 170~280VAC (UPS mode)

Input Max Voltage 300VAC

Input/Output Frequency 50Hz / 60Hz

Output Voltage 230VAC±5%

Output Waveform Pure Sine Wave

Output Regulation < 3% RMS for battery voltage range

Output Short Circuit Circuit Breaker

Peak Efficiency >95% (line mode) / 91% (inverter mode)

Nominal DC Voltage 12V 24V 48V 12V (24V)

Transfer Time <10ms (UPS mode), <20ms (Appliance mode) **

Charging Mode 3-stage

MAX DC Input 15V 15V 30V 60V

Bulk Volt (Flooded, AGM) 14.6, 14.1V 29.2, 28.2V 58.4, 56.4V 14.6, 14.1V (29.2, 28.2V)

Float Volt 13.5V 27.0V 54.0V 13.5V (27V)

AC Recharging Current 10/20amp 20/30amp 60 amp 60 amp

No Load Consumption <15W <25W <50W <25W

Power Saving Consumption <5W <10W <15W <10W

SOLAR CHARGER

Type, Max Charging Current PWM, max 50 Amp

System DC Voltage 12V 24V 48V 12V (24V)

Max PV Input Voc 30V 60V 90V 40V (75V)

Standby Power 1W 2W 1W (2W)

ENVIRONMENTAL / MECHANICAL SPECIFICATIONS

Certification CE

Operating/Storage Temp. 0°C ~ 55°C / -15°C~ 60°C

Operating Humidity 20~90%RH Non-Condensing

Dimension 316*240*95mm 355*272*100mm 468*295*120mm 355*272*100mm

Net Weight 5.0Kg 6.5Kg 7.0Kg 10Kg 10Kg 6.8Kg

Only 48V models are PARALLEL–READY. Optional Parallel Kit isrequired for all units in parallel

and sold separately.

AC CHARGER

PURE SINE WAVE

HIGH FREQUENCY

LCD DISPLAY

MONITORING

STACKABLE*

PB ACID /LIFEPO4

* Only on 48v models

Note: Product specifications are subject to change without prior notice. MPP Solar is a registered trademark of MPP Solar Inc.

*For LiFePo4 suitability, please check with your battery supplier on charging and BMS requirement.

** Inverter-Generators are recommended for better compatibility

**Product specifications are subject to change without prior notice. MPP Solar is a registered trademark of MPP Solar Inc.

Optional Accessories

This accessory is applicable only to

select 48VDC models of HS and MS series

inverters. It is a required component to

be installed in every unit of a parallel

system. A parallel kit includes:

● 1 X PARALLEL BOARD

● 1 X PARALLEL COMM CABLE

● 1 X CURRENT SHARING CABLE

This device is an extension of the HS/MS inverter’s

LCD module and allows user to implement control

on settings and monitoring from a distance away.

This remote module can coexist with the built-in

LCD device and is compatible with most

12v/24v/48v models in the HS/MS inverter series*.

Maximum operating distance: 15m via RJ45

network cable

*This accessory is not fully compatible with 1212HS and 1212MS. Some parameters may not show

**For more details on pricing, availability and installation guide, please contact us directly.

*IMPORTANT: please do not wire 12v or 24v HS/MS inverters in parallel, as this will result instant

damage of all units!

MPP Solar Inc. reserves the right to change product specification without notice. MPP Solar is a registered trademark.

● NEW! energy-efficient power factor 1.0 design

● Special designed for price sensitive consumers

● Lighter in weight, 1-5KW available

● Equalization charging available

● Increased DC limit up to 33V/63V

● Increased bulk/float voltage up to 31.5V/61V

● Fuse protection against reverse battery

● High frequency pure sine wave design

● PMW & MPPT models available

● Suitable for Off-Grid or with Grid

● Programmable parameters

● Max up to 60A utility charging

● Adjustable charging voltage

● Wide AC input range

● Lightweight, easy to install

● 2X surge capacity max 5s

● FREE monitoring software

● LCD Display + LED indicators

● USB communication interface

MAIN FEATURES

HIGH DC VOLT 33V/63V EQUALIZATION CHARGING

COMPACT DESIGN FUSE PROTECTION (DC

REVERSE POLARITY)

Max 31.5V @ 24V

Max 61.0V @ 48V

PIP-HSE/MSE 1012HSE 2024HSE 3024HSE 3024MSE 3024MSXE 5048HSE 5048MSE

ELECTRICAL SPECIFICATION

Continuous Output 1000W 2000W 3000W 3000W 3000W 5000W 5000W

Surge Rating 2X

Input Power Factor 1

Input Voltage Range 90~280VAC (Appliance mode), 170~280VAC (UPS mode)

Input/Output Frequency 50Hz / 60Hz

Output Voltage 230VAC±5%

Output Waveform Pure Sine Wave

Output Short Circuit Circuit Breaker

Peak Efficiency 93%

Nominal DC Voltage 12V 24V 48V

Max DC Input 16V 31V 33V 63V

Transfer Time <10ms (UPS mode), <20ms (Appliance mode)

Charging Mode 3-stage

Max AC Charging Current 20A 20A 25A 60A 60A

Max Equalization Charge 15V 30V 31.5V 61V

No Load consumption <25W <55W

SOLAR CHARGER SPECIFIATIONS

Charging Algorithm PWM PWM PWM MPPT MPPT PWM MPPT

Max Charging Current 50A 50A 50A 40A 60A 50A 60A

Max PV Input Voc 55V 80V 80V 105V 145V 105V 145V

MPPT Range N/A N/A N/A 30 ~ 80V 30 ~ 115V N/A 60 ~ 115V

ENVIRONMENTAL / MECHANICAL SPECIFICATIONS

Certification CE

Operating/Storage Temp. 0°C ~ 55°C / -15°C~ 60°C

Operating Humidity 20~90%RH Non-Condensing

Dimension 320*225*88mm 334*285*100mm 400*300*100mm

Net Weight 5.0Kg 5.8Kg 6.5Kg 9.5Kg 9.0Kg 10Kg

MPP Solar Inc. reserves the right to change product specification without notice. MPP Solar is a registered trademark.

● NEW! 1.6KW—4KW available

● Special revised for OEM volume markets

● Lighter in weight, more integrated design

● Equalization charging available

● Increased DC limit up to 33V/63V

● Increased bulk/float voltage up to 31.5V/61V

● Fuse implementation against battery reversepolarity

● High frequency pure sine wave design

● PMW & MPPT models available

● Suitable for Off-Grid or with Grid

● Programmable parameters

● Max up to 60A utility charging

● Adjustable charging voltage

● Wide AC input range

● Lightweight, easy to install

● 2X surge capacity max 5s

● FREE monitoring software

● LCD Display + LED indicators

● USB communication interface

MAIN FEATURES

HIGH DC VOLT 33V/63V EQUALIZATION CHARGING

COMPACT DESIGN FUSE PROTECTION (DC

REVERSE POLARITY)

Max 31.5V @ 24V

Max 61.0V @ 48V

PIP-HSE/MSE 1624HSE 2424HSE 2424MSE 2424MSXE 4048HSE 4048MSE

ELECTRICAL SPECIFICATION

Continuous Output 1600W 2400W 2400W 2400W 4000W 4000W

Surge Rating 2X

Input Power Factor 0.8

Input Voltage Range 90~280VAC (Appliance mode), 170~280VAC (UPS mode)

Input/Output Frequency 50Hz / 60Hz

Output Voltage 230VAC±5%

Output Waveform Pure Sine Wave

Output Short Circuit Circuit Breaker

Peak Efficiency 93%

Nominal DC Voltage 24V 48V

Max DC Input 32V 63V

Transfer Time <10ms (UPS mode), <20ms (Appliance mode)

Charging Mode 3-stage

Max AC Charging Current 20A 25A 60A 60A

Equalization Charge Yes (max 31.5V@24V, 61V@48v)

No Load consumption <25W <55W

SOLAR CHARGER SPECIFIATIONS

Charging Algorithm PWM PWM MPPT MPPT PWM MPPT

Max Charging Current 50A 50A 40A 60A 50A 60A

Max PV Input Voc 75V 75V 100V 145V 105V 145V

MPPT Range -- -- 30 ~ 80V 30 ~ 115V -- 60 ~ 115V

ENVIRONMENTAL / MECHANICAL SPECIFICATIONS

Certification CE

Operating/Storage Temp. 0°C ~ 55°C / -15°C~ 60°C

Operating Humidity 20~90%RH Non-Condensing

Dimension 320*225*88mm 330*285*90mm 400*300*100mm

Net Weight 5.8Kg 6.5Kg 11Kg 11Kg 13Kg