New Employee Safety Orientation 1 Safety Statistics Fourteen thousand Americans die from on- the-job accidents every year A worker is injured every 18.

1

New Employee Safety Orientation

2

Safety Statistics

• Fourteen thousand Americans die from on-the-job accidents every year

• A worker is injured every 18 seconds

• Most accidents occur within an employee’s first six months on a new job

3

School District Responsibility

• Establish and supervise:– A safe and healthful working environment– A written Accident Prevention Program– Safety and health training programs

• Equipment that meets WISHA safety and health standards

• Records of occupational injuries/illnesses

4

Safety Training• Employee Safety Orientation• On-the-Job training• Departmental Safety Meetings • A Hazard Communication program• Emergency Evacuation Plan• A Fire Prevention Plan• A Bloodborne Pathogens Program• Other job-specific programs as determined by

a Job Hazard Analysis

5

Safety Communication

• Safety Bulletin Boards

• Safety notices• Safety

suggestions

6

Safety Committee• Conducts safety inspections• Investigates accidents• Reviews safety policies

and procedures• Reviews work conditions

for accident prevention• Reviews and responds

to safety suggestions and questions

7

Safety Rules• General safety rules

– Observe all safety warning signs

– Maintain housekeeping– Keep emergency

equipment accessible– No horseplay– Wear required PPE

• Disciplinary actions ?????????????

8

Safe Clothing - PPE• Don’t wear loose clothing• Don’t wear jewelry• Wear protective shoes such as hard leather with

slip-resistant soles (steel toes and shanks are a plus)

• Obtain prescription safety glasses• Tie back long hair

9

Personal Protective Equipment

• PPE required throughout the facility• PPE required in specific departments• Recommended PPE• Issuance of PPE

10

Accidents and Injuries

• Promptly report each workplace injury or occupational illness to your supervisor.

• Submit an Incident Investigation Form.• Near-miss reporting also.

11

If an Incident Happens

12

To Whom Do I Go?

Your Supervisor

13

Must be filled out for any accident or injury – no matter how small.

14

Supervisor also adds comments.

15

Filing a Claim• Seek first aid or medical attention if needed.• Inform your supervisor immediately.• Fill-out and submit an Incident Investigation Form. • Do not file an L&I State Fund Claim Form.• Contact NEWSD 101 Claims Administrator @ 509-

789-3516 or 1-800-531-4290 to obtain a claim number. They will help you through the entire process.

16

Evacuation Procedures• Recognize the evacuation

signal and listen for instructions

• Shut down equipment using the emergency stop

• Go directly to the nearest safe exit

• Proceed to the assembly area

17

Reasons for Evacuation

• Natural disasters (e.g., flood, earthquake)• Man-made disasters (e.g., a bomb)• Fire, Smoke, Explosion• Chemical release• Violent intruder incident• Other?

18

Need to Know

• Nearest safe exit and at least one alternative exit route for any building you are in.

• Location of fire alarm pull stations and fire extinguishers.

• Do not go back into the building until cleared by authorized person!

19

• HAZARD COMMUNICATIONS– Federal & State Standards– Written Hazard Communication Program– Employee Information and Training– Hazard Determination– Material Safety Data Sheets (MSDS)– Labels and Other Forms of Warning– Common Violations

MSDS

20

Right To Know – WAC 296-62-054Hazard Communication Program

• Manufactures are to assess the chemical hazards– Produce Labels– Material Safety Data Sheets

21

• Employee Information and Training– Employers must provide you with information and

training on hazards and hazardous substances in your work area

– This must be documented.– This must be accomplished at the time of your

initial assignment and whenever a new hazard is introduced into the work area.

22

• You must be briefed on:– Any operations that involve hazardous chemicals– The location of the Written Hazard

Communication Program– How to determine exposure/release of a

hazardous chemical– Physical and health hazards– Protective precautions– The MSDS– The labeling system

MATERIAL SAFETY DATA SHEETS (MSDS)

CONTENTS......

23

What is a “hazardous chemical”?

• A hazardous chemical is any chemical that can do harm to your body.

• Most industrial chemicals can harm you at some level.

• It depends how much gets into your body.

24

Hazard CommunicationHow do hazardous chemicals

affect the body?

The effect a certain chemical has on the body depends on several factors:

• The physical form of the chemical

• How the chemical enters the body

• The amount of chemical that actually enters the body - the dose

• How toxic (poisonous) the chemical is

25

How Chemicals Enter the BodyThere Are Three Routes of Entry:

• Ingestion – swallowing the chemical

• Inhalation – breathing in the chemical

• Absorption – the chemical soaks through the skin

26

Chemical ToxicityChronic Toxicity and Acute Toxicity

Some chemicals will only make you sick if you get an ‘acute” or high dose all at once. Example - ammonia

Some materials are mainly known for their chronic or long-term effects. Example - asbestos

Most chemicals have both acute and chronic effects. Example – carbon monoxide

27

Identifying the Agent/Product

28

• Labeling– Containers must be labeled with contents -- Includes secondary containers– Label must contain the common and chemical

name of the substance; the fire, reactivity, and health hazards of the substance; protective equipment/procedures required; and the name and address of the manufacturer

CLEAN

ALL

DEGREASER

WARNING:WARNING

29

Safe Use• Read the product labels• Hazardous products must be handled with respect! Read labels and follow

directions carefully. Words to look for: DANGER - WARNING - CAUTION

• Poison: can injure or kill if absorbed through the skin, ingested or inhaled. • Toxic: can cause injury or death if swallowed, inhaled, or absorbed

through the skin. • Irritant: causes soreness or swelling of skin, eyes, mucous membranes, or

respiratory system. • Flammable: easily catches fire and tends to burn rapidly. • Flammable Liquid: has a flash point below 140°F (100°F for US DOT

purposes). • Combustible Liquid: has a flash point from 140°F (100°F for US DOT

purposes) to 200°F • Corrosive: a chemical or its vapors that can cause a material or living

tissue to be destroyed.

30

May be harmful if swallowed

Indicates a risk of exposure through ingestion. Do not eat, drink or smoke while using this product, and wash hands thoroughly when finished.

Use with adequate ventilation

Indicates a risk of exposure through inhalation. Work outdoors, use in an area with very good airflow to the outdoors, or wear an appropriate respirator.

Avoid skin contact

Indicates a risk of exposure through skin absorption or that the product could damage the skin. Wear appropriate gloves and protective clothing.

Avoid eye contactIndicates a risk of eye damage. Wear chemical splash goggles.

Avoid if pregnantIndicates that the product could harm a developing fetus.

SAFE USEHow do you identify if a product is

hazardous?Read the labelLabel

31

HMIS Hazardous Labeling System

The Hazardous Materials Identification System, HMIS®, was developed by the National Paint & Coatings Association (NPCA) to help employers comply with OSHA's Hazard Communication (HCS), 29 CFR 1910.1200. The system utilizes colored bars, numbers and symbols to convey the hazards of chemicals used in the workplace.

32

NFPA hazard diamond

Health Hazard

Flammable

Instability

Special Hazards

33

Health Hazard4

Very short exposure could cause death or serious residual injury even though prompt medical attention was given.

3Short exposure could cause serious temporary or residual injury even though prompt medical attention was given.

2Intense or continued exposure could cause temporary incapacitation or possible residual injury unless prompt medical attention is given.

1Exposure could cause irritation but only minor residual injury even if no treatment is given.

0Exposure under fire conditions would offer no hazard beyond that of ordinary combustible materials.

34

Flammability

4Will rapidly or completely vaporize at normal pressure and temperature, or is readily dispersed in air and will burn readily.

3Liquids and solids that can be ignited under almost all ambient conditions.

2Must be moderately heated or exposed to relatively high temperature before ignition can occur.

1 Must be preheated before ignition can occur.

0 Materials that will not burn.

35

Instability4

Readily capable of detonation or of explosive decomposition or reaction at normal temperatures and pressures.

3Capable of detonation or explosive reaction, but requires a strong initiating source or must be heated under confinement before initiation, or reacts explosively with water.

2Normally unstable and readily undergo violent decomposition but do not detonate. Also: may react violently with water or may form potentially explosive mixtures with water.

1

Normally stable, but can become unstable at elevated temperatures and pressures or may react with water with some release of energy, but not violently.

0Normally stable, even under fire exposure conditions, and are not reactive with water.

36

This section is used to denote special hazards. There are only two NFPA 704 approved symbols:

Special Hazards

ACID This indicates that the material is an acid, a corrosive material that has a pH lower than 7.0

ALK This denotes an alkaline material, also called a base. These caustic materials have a pH greater than 7.0COR This denotes a material that is corrosive (it

could be either an acid or a base).This is a another symbol used for corrosive

The skull and crossbones is used to denote a poison or highly toxic material.

The international symbol for radioactivity is used to denote radioactive hazards; radioactive materials are extremely hazardous when inhaled.

Indicates an explosive material. This symbol is somewhat redundant because explosives are easily recognized by their Instability Rating.

OX This denotes an oxidizer, a chemical which can greatly increase the rate of combustion/fire.

           Unusual reactivity with water. This indicates a potential hazard using water to fight a fire involving this material.

37

Common ViolationsUnlabeled Secondary

Container Not sealed

Using food or beverage container

38

• Material Safety Data Sheets– Provide vital information about hazardous

chemicals– There must be an MSDS available for every

chemical on the Hazardous Inventory– They must be accessible to you 24 hours a day in

the immediate work area (defined as available during shift).

Will be called Safety Data Sheet’s after 2013

39

• The MSDS is used by chemical manufacturers and vendors to convey hazard information to users.

• MSDS’s should be obtained when a chemical is purchased.

• MSDS must be available to all workers

MSDS

17

SDS’s will be standardized

40

READING THE MSDSInformation on the MSDS is organized in sections as follows:

• Identity The chemical name, trade name and manufacturers name, address and emergency phone number can be found here.

• Ingredients Chemical ingredients are identified.• Hazards Identification: Flammable, Toxic Etc

and health effects• First Aid• Fire Data Flash point, flammable limits,

extinguishing media, unusual fire/explosion hazards, and any special fire fighting equipment are listed here.

Continued on next slide...

41

Reading the MSDSSections Continued

• Accidental Release• Handling and Storage• Exposure Control and Personal Protection• Physical and Chemical Properties• Stability and Reactivity; includes what to avoid• Toxicological Properties• Ecological Information• Disposal Considerations• Transpiration information• Regulatory information• Other information

ELECTRICAL HAZARDS

42

43

How to Prevent Electrical Injuries

Also Avoid the following

Safety Tips • Never carry a tool, appliance or device by the cord. • Never yank the cord to disconnect it from the receptacle. • Keep cords away from heat, oil, and sharp edges • Disconnect items when not in use, toasters, hot plates, coffee pots, vacuums, steam cleaners, etc

44

Take great care not to overload extension cords, power strips or outlets and do not connect multiple extension cords together.

45

Cord damageA cord may be damaged by door or window edges, by staples and fastenings, by abrasion from adjacent materials, or simply by aging. If the electrical conductors become exposed, there is a danger of shocks, burns, or fire.

StrainStraining a cord can cause the strands of one conductor to loosen from under terminal screws and touch another conductor.

Ground pinRemoving the ground pin from a plug to fit an ungrounded outlet

46

How we hurt our backs

• Lifting heavy items.• Pushing or pulling heavy

items.• Taking objects from

shelves.• Picking items off of floor

or ground

• Repetitive motions such as vacuuming, wiping, scanning, or key boarding.

• Twisting or turning while lifting or carrying objects

Safe Lifting

• Do “toe test” to determine how heavy an object is.

• Hold Load Close to Body.• Break Loads Down to

Manageable Size.• The body should never be

turned or twisted while under the stress of heavy weight.

• Do the actual lifting with your legs only.

• Get Help!!!

47

48

Slips, trips and fallsAbout 50% of reported

slips in NEWESD 101 Schools are from snow or ice.

These frequently happen when getting out of vehicle or walking across the parking lot.

Biggest factors include: unaware of ice, footwear without adequate traction, and walking too fast.

49

Reducing injuries

• Wear appropriate footwear for conditions.

• Wear traction cleats if ice is anticipated.

• Walk slowly and deliberately – don’t rush!

• Keep hands free for balance and to catch yourself.

• Lean slightly forward when you walk. Less chance of serious injury if you don’t fall on your back.

• Report unsafe conditions immediately!

50

Things we Trip on

• Stairs• Boxes• Holes in ground• Uneven pavement

• Rugs and mats• Table legs/chair legs• Power Cords• Other: people on floor,

pens, fruit

Most trips are avoidable with situational awareness andgood housekeeping.

51

Things we fall from

• Ladders • Chairs• Stairs• Desks• Stage

52

Preventing Fall Injuries

• Use an appropriate ladder- never use a chair or a desk instead of a ladder.

• Stay within the frame of the ladder – “belt buckle rule.”

• If you routinely use a ladder you must be trained annually.

• Stay alert to leading edge of stage.• Do not rush going up or down stairs.

53

• Exits, evacuation routes, alarm pull stations

• Fire extinguisher locations• First-aid kits• MSDS location(s)• Safety showers and eyewash

stations• Areas where special PPE is

required

Conclusion: Facility Walk-through