Network Cabling Sorrento Valley 877-728-8352

Do’s and Don’ts of Data Network Cabling

By: Mark Allen

When commencing with operations to install data network cabling, there area number of Do’s and Don’ts..…

First, it is important to note that if youare installing the data network cabling in an unfinished home, or office, regardless of the size of the job, it will be an easier task than in an already completed building.

NetworkCablingSanDiego.com 877-728-8352

Second, regardless of how large or small your data cable network is going to be, it is vital to have a home-run location. This is the location where all of your cables will terminate.

This unit should be a structured media centerthat can be flush mounted prior to the completion of the building and should be large enough to accommodate both your present and any future expansion plans for your data network


DOCross Power the Cat5 cables at a 90º angle.

It is not always possible tokeep both data network cabling and data network cables completely separate, and is virtually impossible to keep them from crossing at certain points in the construction process.

If they must cross, theyshould be kept at a ninety degree angle to avoid any serious interference.


DON’TEver mix the color scheme of your data network cabling,

Keep all of your data/voice cabling dependent on one color that you wish to install cabling for:

For example use white cabling for telephoneand voice traffic line one, black for line two, yellow for line three, blue for data, etc.


DOLabel your Cabling.

As each piece of data network cabling is strung, itshould be labeled as to which office or room it is destined for, and how it was terminated, whether it be for Ethernet or a jack for the telephone. Using an indelible ink pen is perfect for this job.

DON’T

Run Cat5 cables right alongside power cables as this most typically causes interference on the data network cabling.


DO

Run Ethernet cabling everywhere

Particularly if you have access to open walls during the construction phase of the office or home.

If you are going to the trouble of installing data network cabling, it is good to have it in as many places as possible for easy access. Even if you only have one Ethernet port in a room, a router can be fitted to allow for more at a later stage.


DON’TBundle the data networking cable too tightly

It is fine for you to run telephone, data and coaxial video cable together but the bundles of cablesshould definitely not be tied into tight bundles.

Cable turns should be soft; a kinked cable could have a negative impact on the network throughout.

DOKeep your cables segregated and plan for any future growth

Ensure that there is room to run more data network cabling in the future, particularly if the cabling is being strung during the construction phase of the building.


DOUse mud rings

They are far more practical for telephone Ethernet andcoaxial cables and as they are low voltage, the cables do not need to be terminated


Network Cabling Sorrento Valley 877-728-8352

Technology

piece of data network

installdata network

data networkcabling

white cabling

data networking cable

datacable network

datavoice cabling dependent

power cables