MTTR mobitower Design Materials The standard supply provides the minimum configuration required for mobitower commissioning, excluding radiant systems and mounts. • equipment and power container (special container 20”) • steel interface frame • retracting stabilizers with adjustable jacks • access ladder to the container roof and parapets on the container roof • antenna support pole consisting of telescopic aluminium pole • antenna pipe mount complete with brackets for 3 panel antennas • climbing ladder with rigid anchor line (EN 353-1) on base shaft of the pole • vertical fixing system for feeders and service cables • guys consisting of galvanized steel cables with relative turnbuckles in ancillaries box. • installation, use and maintenance manual For a description of the accessories and ordering information, please refer to the Accessories catalogue. Structural steel design according to the most recent European Standard. Designs to other International Standards (EIA, BS, NV65) available upon request. • Constant max wind speed on entire height 150 km/h • Constant operational wind speed on entire height 100 km/h • Top deflection (at operational wind speed) <0.5° The mobile trucks with container and with self-mounting telescopic mast are portable structures that guarantee full operation in three hours and in restricted spaces. Their use is strategic for the rapid extension of cellular networks, putting into service point to point radio connections, as well as supporting to the increased traffic volume in case of extraordinary events (trade fairs, sport events and concerts, emergencies, catastrophic events, etc.). The steel interface frame is made of galvanized steel beams and is provided with four retracting stabilizers that can be retracted under the container for transport. The equipment and power container, which has a reinforced special 20” box container with two access doors, divided by an intermediate partition to create two separate rooms (E and A). Room A is used for housing the electrical and radio equipment. Room E is used as a power room for housing the generating set; and also, during transport, to contain the radiant systems and accessory components. The antenna supporting pole, with standard height of up to 20 meters, is made of aluminium and comprises of three telescopic tubular elements. Installation is easy, fast and is carried out with manual winches. All legal rights in this document are the exclusive property of calzavara and no part of it may be reproduced or communicated to any other party without our authorization. All data in this catalogue is for reference only and may be changed without notice, in line with our policy of continuous technical development. calzavara - tel. +39 0432 84381 www.calzavara.it [email protected] - mobile & kit radio stations 2009 - page 40 COT Cell on Truck MTTR mobitower Supply The materials comply with the requirements of European Standards (EURONORM). STEEL FRAME AND CONTAINER • Structural parts S275JR (Fe 430 B) EN 10025 S235JR (Fe 360 B) EN 10025 • Nuts and bolts class 8.8 EN 20898-1 ALUMINIUM POLE • Structural parts aluminium alloy EN-AW-6060 T6 EN 573-3 • Pins stainless steel X8CrNiS18-9 (AISI 303) EN 10088-3 • Nuts and bolts class 8.8 EN 20898-1 All steel materials are protected by hot-dip galvanizing in accordance to Euronorm EN 1461 and ASTM A123 Standards.