http://www.robokits.co.in http://www.robokitsworld.com Page 1 AVRISP MKII - Ultra Speed Programmer for Mega, Xmega and Tiny AVR [RKI-1811] AVRISP MKII - Ultra Speed Programmer for Mega, Xmega and Tiny AVR [RKI-1811] Users Manual Robokits India http://www.robokits.co.in [email protected]
12
Embed
MKII USB programmer - robokits.downloadrobokits.download/documentation/AVRISP_MKII.pdf · Atmel Studio 6 software can be used with AVRISP MKII USB Programmer hardware to provide all
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
AVRISP MKII - Ultra Speed Programmer for Mega, Xmega and Tiny AVR [RKI-1811]
Thank you for purchasing the Robokits AVRISP MKII Programmer. This unit has been carefully
engineered and tested to provide superior performance. This document covers the features and
operation of the AVRISP MKII USB Programmer.
AVRISP MKII programmer is a ultra speed programmer for whole Atmel AVR series. The
programmer supports Mega AVR(ISP), Xmega AVR(PDI) and TinyAVR (TPI) interfaces. This is
only a programmer and no debugger. It is compatible with Atmel Studio 6. Works on jungo USB
drivers given with Atmel studio making it compatible with all windows OS. Features
• Compatible to Atmel's AVRISP MKII with ISP, PDI and TPI support • Compatible with Atmel Studio 6 via AVRISP MKII protocol • Adjustable ISP clock allows flashing of devices clocked at very low to high rate, e.g. 32
kHz, 8MHz • Ultra High Speed Programming : Programming and verification of 32 KB flash in just 5
seconds • Uses USB power supply, no external supply required • Jumper setting for 3.3V and 5V target devices • Supports full XMEGA series of Atmel • Also supports few Tiny ics having just 6pin and not compatible to ISP mode
programming via TPI mode
Atmel Studio 6 software can be used with AVRISP MKII USB Programmer hardware to provide all the of the necessary functions like read, write, lock, and fuse settings.
Led Indication
• USB LED: Will turn on When USB is connected.
• Programming LED: will turn on when the device is getting programmed.
Jumper Usage
• USB SUPPLY: USB power will be given to the target via VTARGET pin.
• TARGET 5V: If your device is 3.3V compatible remove this jumper if it is 5V compatible please keep jumper shorted.
AVRISP MKII - Ultra Speed Programmer for Mega, Xmega and Tiny AVR [RKI-1811]
Service and Support
Service and support for this product are available from Robokits India. The Robokits Web site (http://www.robokits.co.in) maintains current contact information for all Robokits products. Limitations and Warrantees The AVRISP MKII - Ultra Speed Programmer for Mega, Xmega and Tiny AVR [RKI-1811] is intended for personal experimental and amusement use and in no case should be used where the health or safety of persons may depend on its proper operation. Robokits provides no warrantee of suitability or performance for any purpose for the product. Use of the product software and or hardware is with the understanding that any outcome whatsoever is at the users own risk. Robokits sole guarantee is that the software and hardware perform in compliance with this document at the time it was shipped to the best of our ability given reasonable care in manufacture and testing. All products are tested for their best performance before shipping, and no warranty or guarantee is provided on any of them. Of course the support is available on all of them for no cost.