Specifications Additional information can be found online at www.heatnglo.com MODEL HEIGHT FRONT WIDTH BACK WIDTH DEPTH VIEWING AREA Actual Framing Actual Framing Actual Framing Actual Framing 51-1/8" [1299] 62" [1575] 15-5/8" [397] 42-1/2" [1080] 4" [102] 8-9/16" [217] 63" [1600] 8-9/16" [217] 1" [25] 58" [1473] 17-1/8" [435] 18-5/8" [471] 41-3/4" [1060] 2-3/8" [60] 8-9/16" [217] 24-1/2" [622] 8-7/8" [225] 2-3/4" [70] 7-1/4" [184] 23-3/4" [603] GAS ACCESS ELECTRICAL ACCESS CENTERED ON APPLIANCE Ø 8" [203] Please consult the manufacturer’s installation manual for all details and requirements before making a final design layout decision. MEZZO48 48" Direct Vent Gas Fireplace MEZZO48 MODEL FRONT WIDTH BACK WIDTH HEIGHT DEPTH GLASS SIZE MEZZO48 Actual Framing Actual Framing Actual Framing Actual Framing 47-1/2 x 12-1/2 58 60-1/4 58 60-1/4 41-3/4 42 17-1/8 18-1/4 Top Front Left Right
3
Embed
MEZZO48 - Hearth N Homedownloads.hearthnhome.com/architectGuides/MEZZO_MEZZO48_ArchGuide.pdf48" Direct Vent Gas Fireplace MEZZO48 MODEL FRONT WIDTH BACK WIDTH HEIGHT DEPTH GLASS SIZE
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Specifications
Additional information can be found online at www.heatnglo.com
MODEL HEIGHT FRONT WIDTH BACK WIDTH DEPTH VIEWING AREA
Actual Framing Actual Framing Actual Framing Actual Framing
51-1/8" [1299]62" [1575]
15-5/8"[397]
42-1/2"[1080]
4"[102]
8-9/16"[217]
63"[1600]
8-9/16"[217]
1" [25]58" [1473]
17-1/8"[435]
18-5/8"[471]
41-3/4"[1060]
2-3/8"[60]
8-9/16"[217]
24-1/2"[622]
8-7/8"[225]
2-3/4"[70]
7-1/4"[184]
23-3/4"[603]
GAS ACCESS ELECTRICAL ACCESS
CENTERED ON APPLIANCEØ 8" [203]
Please consult the manufacturer’s installation manual for all details and requirements before making a final
design layout decision.
MEZZO4848" Direct Vent Gas Fireplace
MEZZO48
MODEL FRONT WIDTH BACK WIDTH HEIGHT DEPTH GLASS SIZE
MEZZO48Actual Framing Actual Framing Actual Framing Actual Framing
47-1/2 x 12-1/258 60-1/4 58 60-1/4 41-3/4 42 17-1/8 18-1/4
Additional information can be found online at www.heatnglo.com
Product information provided is not complete and is subject to change without notice. Product installation must adhere strictly to instructions accompanying product to avoid risk of fire and potential injury.
MEASUREMENTS FROM TOP EDGE OF THE APPLIANCE OPENING
4
5
6
13-16
3
2
1
67
89
1011
18
31
MAX.
MIN.
TO CEILING
Measurement from top edge of openingto bottom of appliance = 24-1/2 IN.
OVERLAP FIT
MEASUREMENTS FROM TOP EDGE OF THE APPLIANCE OPENING
4
5
6
14-16
0-910
18
31 MIN.
MAX.
TO CEILING
Measurement from top edge of openingto bottom of appliance = 24-1/2 IN.
7
11
INSIDE FITNote: All measurements in inches.
MEASUREMENT FROMTOP EDGE OPENING
18 2023
2629
31
TO CEILING
912
63
1
Measurement from top edge opening to bottom of appliance = 24-1/2"
MAX.
Note: All measurements in inches.
APPLIANCE LOCATION
100-3/8"[2550]
70-3/4"[1797] 60-1/4
[1530]**
60-1/4[1530]**
60-1/4 [1530]**
60-1/4 [1530]**
18-1/4"[464]
28-1/2"[724] 1"
[25]
1"[25]
See clearancesin install manual
Refer to Section 10 of install manual for hearth, mantel and wall projection information. If a HEAT-ZONE® or HEAT-DUCT will be installed,refer to Section 5.E of install manual for information.
2 HEAT-ZONES = Add 4" to ** dimension1 HEAT-ZONE = Add 2" to ** dimension
MANTEL LEG/WALL PROJECTIONS
WALL PENETRATION
3 ft. maximum4-1/2"minimum
FIREPLACE OPENINGSee Appliance dimension diagram in install manual - Dimension B
Note: Clearance from opening to perpendicualar wall
Top View
FIREPLACE OPENINGSee Appliance dimension diagram in install manual - Dimension B
Note: Clearance from opening to perpendicualar wall
Top View
7"minimum UNLIMITED
Combustible Non-CombustibleAcceptable on both sides of opening
63"[1600]
10" 12"
63"[1600]
Do not pack with insulation orother material
* Shows center of vent framinghole for top venting. Center of holeis 1" [25] above center of horizontalvent pipe.
42"[1067]
60-1/4"[1530]
10"[254]
HEADERDEPTH**
18-1/4"[464]
APPLIANCE MAY BE INSTALLED OFF OF FLOOR***
* Adjust framing dimensions for interior sheathing (such as sheetrock)** Header depth not to exceed 3-1/2".*** If appliance is installed off the floor, maintain required clearances to combustibles Construct platform in accordance with local building codes.