8/9/2019 manual trendnet Tew-450apb(c1.0r
1/11
TEW-450APB
Quick Installation Guide
8/9/2019 manual trendnet Tew-450apb(c1.0r
2/11
Table of Contents
English ......................................................................................................
Troubleshooting ........................................................................................
1
12
3
6
1. Before You Start2. Install Hardware .................................................................................
3. Configure the Access Point ................................................................
.................................................................................
Table of Contents
Version 09.18.2007
8/9/2019 manual trendnet Tew-450apb(c1.0r
3/11
Installation Requirements
Application
Package Contents
1. Before You Start
English
1
1 x 2dBi Detachable Antenna
T 450APB
Quick Installation Guide
External Power Adapter
Users Guide CD-ROM
EW-
Netscape Navigator (4.7 or higher)
A computer with a network adapter properly installed
A network Switch or Hub with an available network LAN port
A RJ-45 network cable
A web browser such as Internet Explorer (5.5 or higher) or
Notebook with 108MbpsWireless PC Card(TEW-441PC)
Cable/DSLModem
Internet
Workstation with 108MbpsWireless PCI Adapter(TEW-443PI)
Workstation with 108MbpsWireless USB 2.0 Adapter
(TEW-444UB)
Cable/DSL 4-PortFirewall Router
(TW100-BRF114)
Wireless Super G Access Point(TEW-450APB)
8/9/2019 manual trendnet Tew-450apb(c1.0r
4/11
2. Install Hardware
English
2
2. Connect the AC Power Adapter tothe Access Point and then to apower outlet.
Note: Locate an optimum location for the Access Point. The best place for theAccess Point is usually at the center of your wireless network. Please connectthe computer configuring the TEW-450APB to the same switch/hub.
1. Connect a RJ-45 cable from theSwitch/Hub to the LANport of theAccess Point and then connect the2dBi Detachable Antenna.
3. Verify that the following front panellights are on: LAN and WLAN.
8/9/2019 manual trendnet Tew-450apb(c1.0r
5/11
English
3
3. Configure the Access Point
Note: It is recommended that you configure the Access Point from a wiredcomputer. Before the Access Point can be configured, a Static IP addressmust be assigned to your computer's network adapter in the subnet of192.168.10.x. Since the Access Point's default IP address is 192.168.10.100,
make sure no other network devices are assigned an IP address of192.168.10.100. (Refer to the Troubleshooting section on how to configureTCP/IP settings on your PC)
For a Wired Computer
2. Enter User name and Password,and then click OK. By default,User name: adminPassword: admin
1. Open your web browser, typehttp://192.168.10.100in theAddress bar, and press Enter.
3. Click Wizard.
8/9/2019 manual trendnet Tew-450apb(c1.0r
6/11
English
4
5. Enter a new password for yourAccess Point, verify the newpassword, and then click Next. (If anew password is not entered, the
default password adminwill beused.
4. Click Next.
6. Enter a SSID for your AccessPoint and then click Next.
8/9/2019 manual trendnet Tew-450apb(c1.0r
7/11
English
5
8. Click Restart.
7. Enable Encryption if needed and
then click Next.
9. Click Close.
Your installation is now complete.
For detailed information regarding the TEW-450APB's configuration andadvanced settings, please refer to the Troubleshooting section, User's GuideCD-ROM, or Trendnet's website at http://www.trendnet.com.
8/9/2019 manual trendnet Tew-450apb(c1.0r
8/11
Q2:
A2:
Q3:
A3:
I specified the IP address http://192.168.10.100 in my Internet Browser'sAddress Bar, but an error message says "The page cannot be displayed". Howcan I get into the TEW-450APB's web configuration page?
First, check your hardware settings again by following the instructions insection 2. Second, make sure the LAN and WLAN lights are lit. Third, make surethe TCP/IP settings are configured properly (see Q1). Fourth, since the AccessPoint's default IP address is 192.168.10.100, make sure that no other networkdevices are assigned an IP address of 192.168.10.100.
If my network's IP is different than the Access Point's range, what should Ido?
You should still configure the Access Point first. After all the settings areapplied, go to the Access Point's configuration page, click on TCP/IP settings andchange the IP address of the Access Point to match your network's IP.
6
Troubleshooting
Q1: How do I configure TCP/IP settings on my computer?
1. Go into the Control Paneland double-click the Network Connectionsicon,right-click the Local Area Connectionicon and then click Properties.
2. Click Internet Protocol (TCP/IP)andthen click Properties. Then click onUse the following IP address, andmake sure you assign your networkadapter an IP address in the subnet of192.168.10.x.
8/9/2019 manual trendnet Tew-450apb(c1.0r
9/11
7
Q4:
A4:
Q5:
A5:
After I successfully configured the Access Point to meet my network settings,I can not connect to my network using wireless computers.
If you have a DHCP server in your network, you need to go into TCP/IP
settings again and re-select "Obtain an IP address automatically" to allow the PCto regain an IP address from your DHCP server.
All the settings are correct, but I can not make a wireless connection to theAccess Point.
First, double check that the WLAN light on the Access Point is lit. Second,power cycle the Access Point by unplugging the power to the Access Point. Wait15 seconds, then plug the power back in. Third, contact the manufacturer of yourwireless network adapter. Make sure the wireless network adapter is configured
with the proper SSID. The default SSID of the Access Point is TRENDnet.
If you still encounter problems or have any questions regarding the TEW-450APB,please contact TRENDnet's Technical Support Department.
Register Your ProductTo ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/registerThank you for choosing TRENDnet
8/9/2019 manual trendnet Tew-450apb(c1.0r
10/11
CertificationsThis equipment has been tested and found to comply with FCC and CE Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that maycause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TVINTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THISEQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USERS AUTHORITY TOOPERATE THE EQUIPMENT.
Waste electrical and electronic products must notbe disposed of with household waste. Pleaserecycle where facilities exist. Check with you LocalAuthority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador dealimentacn necesario para su funcionamiento. El uso de un adaptador distinto almencionado puede producir daos fisicos y/o daos al equipo conectado. El adaptadorde alimentacin debe operar con voltaje y frecuencia de la energia electrica domiciliariaexistente en el pais o zona de instalacin.
7898431242716
8/9/2019 manual trendnet Tew-450apb(c1.0r
11/11
20675 Manhattan PlaceTorrance, CA 90501USA
roduct Warranty Registration
Please take a moment to register your product online.
Go to TRENDnets website at http://www.trendnet.com/register
ustomer Support
Email:
Europe (Germany France Italy Spain Switzerland UK)
English/Espanol - 24/7Francais/Deutsch - 11am-8pm, Monday - Friday MET
English/Espanol - 24/7Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone:+(31) (0) 20 504 05 35
Toll Free Telephone:+00800 60 76 76 67
. . . . .
Visit www.trendnet.com/support