mahesh Presentation1

8/6/2019 mahesh Presentation1

http://slidepdf.com/reader/full/mahesh-presentation1 1/18

ELECTRICITY GENERATION FROM SPEED

BREAKER

SUBMITTED TO:- SUBMITTED BY:-

Mr. Ashish Kumar Dubey Mahesh Choudhary

Project head (EE)



AbstractAbstract::

y This is a power project based on the fact

that how electricity can be generated with

the help of speed breaker by making gear

arrangement and using electronicsgadgets, thus a huge amount of electricity

can be generated saving lot of money.

And if implemented will be very beneficial

for Government



IntroductionIntroduction::

y Currently there are various methods for electricity

generation. Here is a novel method for generating

electricity from speed breakers which is eco-

friendly.

y In our design, the speed breakers have to be made

with springs. When a vehicle loads a speed breaker

it compresses air and this air is used to drive the

impeller. This serves as a source for the alternator.

y Thus in this model, going to present a new methodof electricity generation. Hope this design will be

implemented soon !!!



Sources of Energy:Sources of Energy:

y The various sources of energy are

y Solar

y Tidal

y Wind etc«

y In this modal we are using the speed

breaker as one of the energy source.



Speed breakers:Speed breakers:

y In Indian roads, currently we have speed

breakers of rigid type, made of steel or

with tar. When a heavy load crosses the

speed breaker it remains unreformed,which alone limits the speed of vehicles

The national highways come with

minimum 8 meters wide, 0.015m

thickness. We are proposing slight

changes in the current roads



Proposed design:Proposed design:

y Here we are making the speed breaker of

vibrating type, when a vehicle crosses the

speed breaker, it gets depressed and

then it gets back to its original position.Dimensions

y Height of speed breaker : 0.2m

y Width of speed breaker : 0.4my Length of speed breaker : 4m

y Material used for speed breaker: Steel





Speed breaker Speed breaker ² ²design:design:

y The speed breakers are fitted withhelical spring at the base. The shapeof speed breaker is trapezoidal,

because when a vehicle comes topoint A, the load will be acting between A and B.

y The dimensions are

y Height: 0.35m

y Length : 4m

y Width :0.45m



Impact of vehicle on speedImpact of vehicle on speed

breakerbreaker



MaximumMaximum loadload onon speedspeed breakerbreaker



Vehicle leaving the speed breakerVehicle leaving the speed breaker



RunnerRunner



y An electrical generator is a machine whichconverts mechanical energy in toelectrical energy. The energy conversion

is based on the principle of production of dynamically induced e.m.f. According toFaraday¶s laws of electromagneticinduction, whenever a conductor cutsmagnetic flux, dynamically induced e.m.f.is produced in it. This e.m.f causes acurrent to flow if the conductor circuit isclosed

Alter nator:Alter nator:



Scope, Merits and Uses:Scope, Merits and Uses:

y Low Budget electricity production

y Less floor area

y No obstruction to traffic

y Easy maintenance

y Suitable at parking of multiplexes,

malls, toll booths, signals, etc.

y Uses: Charging batteries and using

them to light up the streets, etc.



Conclusion:Conclusion:

y In this modal, showing about a newapproach of generation of electricityfrom the speed breaker. This can

generate up to 100Kwatts of power which can be used for variouspurposes. Here we have converted themechanical energy to pneumatic

energy then to electrical energy. Thisdesign will help to reduce the cost of electricity generation







MaheshMahesh choudharychoudhary

y My e-mail address-

[email protected],[email protected]

m. A complete report on ³GENERATING THE

ELECTRICITY FROM A SPEED BREAKER´

available here. Plz send any quries and informationon my e-mail.

mahesh Presentation1

Documents