Magnetism Alternating- Current Circuits
Feb 06, 2016
Magnetism Alternating-Current Circuits
Alternating Current Generators
Alternating current motor
A coil of area A and N turns rotating with constant angular velocity in a uniform magnetic field produces a sinusoidal emf
Instead of mechanically rotating, we can apply an ac potential difference generated by other ac generator to the coil. This produces an ac current in the coil, and the magnetic field exerts forces on the wires producing a torque that rotates the coil.
The magnetic field.
Magnetic forces on moving charges.
Magnetic forces on a current element
Torques on current loops and magnets
The Magnetic FieldMagnets
The Earth is a natural magnet with magnetic poles near the north and south geographic poles.
The Magnetic Field
Magnets Does an isolated magnetic pole exist?
The SI units of magnetic field is the tesla [T]
Earth magnetic field is about 10-4 T
Powerful laboratories produce fields of 1 -2 T as a maximum
1 Gauss [G] = 10-4 Tesla [T]
The Magnetic Field
The Magnetic Field. Magnetic force on a moving charge
A proton is moving in a region of crossed fields E = 2x105 N/C and B = 3000 G, as shown in the figure. (a) What is the speed of the proton if it is not deflected. (b) If the electric field is disconnected, draw the path of the proton
The Magnetic Field. Magnetic force on a current element
In the case of a straight segment of length L
The Magnetic Field. Torques on Current loops and Magnets
A circular loop of radius 2 cm has 10 turns of wire and carries a current of 3 A. The axis of the loop makes an angle of 30º with a magnetic field of 8000 G. Find the magnitude of the torque on the loop.
BA current-carrying loop experiences no net force in a uniform magnetic field, but it does experience a torque that tends to twist the loop
Sources of Magnetic Field
The Magnetic Field of Moving Charges
The Magnetic Field of Currents. The Biot-Savart Law
The Magnetic Field Due to a Current loop
Sources of Magnetic Field
Moving Point Charges are the source of Magnetic Field
A solenoid is a wire tightly wounded into a helix of closely space turns . A solenoid is used to produce a strong, uniform magnetic field in the region surrounded by the loops
For a long solenoid Find the magnetic field at the center of a
solenoid of 600 turns, length 20 cm; radius 1.4 cm that carries a current of 4 A
Sources of Magnetic Field
A solenoid
In this figure, the length is ten times longer than the radius
n = N/L; N number of turns; L : length of solenoid
Sources of Magnetic Field: Solenoid and magnets
Left: Magnetic field lines of a solenoid; right Magnetic field lines of a bar magnet
Magnetic Induction
Magnetic Flux
Induced EMF and Faraday´s Law
Lenz´s Law
MAGNETIC INDUCTIONIn 1830, Michel Faraday in England and Joseph Henry in the USA independently discovered that in a changing magnetic field, a changing magnetic flux through a surface bounded by a stationary loop of wire induces a current in the wire: emf induced and induced current. This process is known as induction.
In a static magnetic field, a changing magnetic flux through a surface bounded by a moving loop of wire induces an emf in the wire: motional emf
Magnetic flux through a surface bounded by a loop of wire.
The SI unit for magnetic flux is weber [Wb] 1Wb= 1 T∙m2 Find the magnetic flux through a 40 cm long
solenoid with a 2.5 cm radius and 600 turns carrying a current of 7.5 A.
The induced emf is in such direction as to oppose, or tend to oppose, the change that produces it. Lenz´s Law
MAGNETIC INDUCTION
The coil with many turns of wire gives a large flux for a given current in the circuit. Thus, when the current changes, there is a large emf induced in the coil opposing the change. This self-induced emf is called a back emf
MAGNETIC INDUCTION
Eddy Currents
Heat produced by eddy currents constitute a power loss in a transformer. But eddy currents have some practical applications: damping mechanical oscillations, magnetic braking system
Inductance Self-inductance The SI unit of
inductance is the henry [H]
1 H = 1 Wb/A= 1 T.m2.A-1
Find the self-inductance of a solenoid of length 10 cm, area 5 cm2, and 100 turns
Magnetic Energy
Alternating Current Generators
Alternating current motor
A coil of area A and N turns rotating with constant angular velocity in a uniform magnetic field produces a sinusoidal emf
Instead of mechanically rotating, we can apply an ac potential difference generated by other ac generator to the coil. This produces an ac current in the coil, and the magnetic field exerts forces on the wires producing a torque that rotaes the coil.
Alternating Current Generators A coil of area A and N turns rotating with constant angular velocity in a uniform magnetic field produces a sinusoidal emf
fffrequency
t
tNBAdt
d
tNBA
tandNBA
peak
m
m
m
2;
)sin(
)sin(
)cos(
cos
Alternating Current Circuits: Alternating current in a Resistor
Inductors in Alternating Currents Capacitors in Alternating Currents
Potential drop across the resistor, VR
Current in the resistor I Power dissipated in the resistor, P Average power dissipated in the resistor Paverage
Alternating currents in a Resistor
R
VIt
R
VI
tVtV
peakRpeak
peakR
peakRR
,,
,max
cos
coscos
RtIRIP
RtIRIP
avpeakavav
peak
))(cos()(
)(cos222
222
Root-Mean-Square Values
Inductors in Alternating Current Circuits
The potential drop across the inductor led the current 90º (out of phase)
Instantaneous power delivered by the emf to the inductor is not zero
The average power delivered by the emf to the inductor is zero.
)2
cos(sincos
coscos
,,,
,max
tL
Vt
L
VIt
L
V
dt
dI
tVtdt
dILV
peakLpeakLpeakL
peakLL
INDUCTIVE REACTANCE L
VI
L
VI rmsL
rmspeakL
peak ,, ;
Inductors in Alternating Current Circuits
Instantaneous power delivered by the emf to the inductor is not zero
The average power delivered by the emf to the inductor is zero.
INDUCTIVE REACTANCE
L
VI
L
VI rmsL
rmspeakL
peak ,, ;
The potential drop across a 40-mH inductor is sinusoidal with a peak potential drop of 120 V. Find the inductive reactance and the peak current when the frequency is (a) 60 Hz, and (b) 2000 Hz
Capacitors in Alternating Current CircuitsThe potential drop lags the current by 90º
Power delivered by the emf in the capacitor: Instantaneous and average
CAPACITIVE REACTANCE
)2
cos(1
sin
cos
coscos
,,
,
,max
t
C
VItCV
dt
dQI
tCVQ
tVtC
QV
peakCpeakC
peakC
peakCC
C
VI
C
VI rmsC
rmspeakC
peak
1
;1
,,
Driven RLC Circuits
Series RLC circuit The Kirchhoff´s rules govern the behavior of potential drops and current across the circuit. (a)When any closed-loop is traversed, the algebraic sum of the changes of potential must equal zero (loops rule)(b)At any junction (branch point) in a circuit where the current can be divided, the sum of the currents into the junction must equal the sum of the currents out of the junction (junction rule)
)cos(
cos
;cos
,
2
,
tII
tVC
QR
dt
dQ
dt
QdL
dt
dQI
C
QIR
dt
dILtV
peak
peakapp
peakapp
Series RLC circuits
Power delivered to the series RLC circuit
coscos2
1
/cos/
coscos2
1
)2
cos(cos
,,
,
22
,2
2
rmsrmsapppeakpeakapp
peakapppeak
rmsapprmsav
rmsrmspeakpeakav
peakpeak
IVIVP
ZVIandZRasZ
RVRIP
resistortheindissipatedRIP
IIP
tItIP
Power factor: cosδ
Series RLC circuits
A series RLC circuit with L = 2 H, C =2 μF and R=20Ω is driven by an ideal generator with a peak emf of 100 V and a frequency of 60 Hz, find (a) the current peak (b) the phase (c) the power factor, (d) the average power delivered; (e) the peak potential drop across each element
Phasors Potential drop across a resistor can be represented by a vector VR, which is called a phasor. Then, the potential drop across the resistor IR, is the x component of vector VR,
Potential drop across a series RLC circuit
C
QIR
dt
dILtVapp cos
In the circuit shown in the figure, the ac generator produces an rms voltage of 115 V when operated at 60 Hz. (a) What is the rms current in the circuit (b) What is the power delivered by the ac generator (c) What is the rms voltage across: points AB; points BC; points CD; points AC; points BD?.
A certain electrical device draws 10 A rms and has an average power of 720 W when connected to a 120-V rms 60-Hz power line. (a ) What is the impedance of the device? (b) What series combination of resistance and reactance is this device equivalent to? (c) If the current leads the emf, is the reactance inductive or capacitive?
The Transformer
Because of the iron core, there is a large magnetic flux through each coil, even when the magnetizing current Im in the primary circuit is very small . The primary circuit consists of an ac generator and a pure inductance (we consider a negligible resistance for the coil). Then the average power dissipated in the primary coil is zero. Why?: The magnetizing current in the primary coil and the voltage drop across the primary coil are out of phase by 90º
11
2222
11
VN
NVNV
NV
dtd
dtd
turn
turn
Secondary coil open circuit The potential drop across the primary coil is
If there is no flux leakage out of the iron core, the flux through each turn is the same for both coils, and then
A transformer is a device to raise or lower the voltage in a circuit without an appreciable loss of power. Power losses arise from Joule heating in the small resistances in both coils, or in currents loops (eddy currents) within the iron core. An ideal transformer is that in which these losses do not occur, 100% efficiency. Actual transformers reach 90-95% efficiency
The Transformer
rmsrmsrmsrms IVIV
ININ
,2,2,1,1
2211
However, the potential drop in the primary is determined by the generator emf According to this, the total flux in the iron core must be the same as when there is no load in the secondary. The primary coil thus draws an additional current I1 to maintain the original flux Φturn. The flux through each turn produced by this additional current is proportional to N1I1. Since this flux equals – Φ´turn, the additional current I1 in the primary is related to the current I2 in the secondary by
These curents are 180 º out of phase and produce counteracting fluxes. Since I2 is in phase with V2, the additional current I1 is in phase with the potential drop across the primary. Then, if there are no losses
A resistance R, load resistance, in the secondary circuit
A current I2 will be in the secondary coil, which is in phase with the potential drop V2 across the resistance. This current sets up and additional flux Φ´turn through each turn, which is proportional to N2I2. This flux opposes the original flux sets up by the original magnetizing current Im in the primary.