Logo system manual_en-us_en-us

LOGO! AM 2 AQ (0 ... 10 V DC)

LOGO! AM2 AQ (0 ... 10 V DC or 0/4 ... 20 mA)

s

s

s

R1

0 ... 10 V

V1, V2: 0 ... 10 V DCR1: >= 5 kΩ

I1, I2: 0/4 ... 20 mAR2: <= 250 Ω

0 ... 10 V

R1 R2

0 ... 10 V 0/4 ... 20mA

R1

V1, V2: 0 ...10V DCR1: >= 5 kΩ

AQ1 AQ2 M1 I1 V2+

1 2 1 2

1 2 1 2 1 2 1 2

1 2 1 2

1 2 1 2 1 2 1 2

Analog outputs Analog inputs Outputs

Inputs

MN

OT

30h 30h 30h 30h

20h100hMI

0 20 40 60 80 100 120

LOGO! functions 4.4 Special functions list - SF

LOGO! 182 Manual, 11/2008, A5E01248535-02

Message Ticking You can configure message text lines to tick or not tick. Two types of message ticking exist: ● Character by character ● Line by line Messages that tick character by character scroll off the characters of the message line one character at a time to the left with the additional characters scrolling in one at a time from the right. The time interval for the tick is specified by the TickTime message text setting. Messages that tick line by line by line scroll one half of the message off the display to the left with the second half of the message scrolling in from the right. The time interval for the tick is ten times the TickTime parameter. The two halves of the message simply alternate on the LOGO! Display or LOGO! TD.

Example: Tick Message Character by Character The following illustration shows a one-line, 24-character message text:

If you set this message to tick "character by character" with a tick interval of 0.1 seconds, then the initial appearance of this message line on the LOGO! Display or LOGO! TD is as shown in this illustration:

After 0.1 second, one character of the message line ticks. The message appears as follows on the LOGO! Display or LOGO! TD: