LINE SEIKI SLIDE COUNTER PRESET SLIDE COUNTER (upper/lower limit output) DIE HEIGHT SLIDE ADJUST COUNTER MODEL : SRP • RLP • RLS • SB series APPLICATIONS MACHINE TOOLS AND VARIETY OF INDUSTRIAL MACHINES. (Ask for the type of mounting and conection apply to your application) TYPES OF REVOLUTION Looking from the top of the shaft (looking from the rear in case of rear shaft, looking from the bottom in case of bottom shaft. ( I ) Revolution to RIGHT is ADD, Revolution to LEFT is SUBTRACT ( II ) Revolution to LEFT is ADD, Revolution to RIGHT is SUBTRACT ( III ) Revolution to LEFT is ADD, Revolution to RIGHT is SUBTRACT ( IV ) Revolution to RIGHT is ADD, Revolution to LEFT is SUBTRACT five figures four figures 1 revolution : 1 count 1 revolution : 10 counts SELECTION OF MODEL NUMBER 1 4 • 1 5 2 4 • 2 5 Model Figure Size Revolution / Count 1 / 10 1 / 10 1 / 1 1 / 1 1 / 1 1 / 1 1 / 1 1 / 1 1 / 1 Digits 4 5 4 4 4 4 4 4 5 RLS-14A (I) FS1 RLS-14A (I) FS RLS-14A (I) S2 RLP-14B (I) S3 SRP-14B (I) S2 SRP-24B (I) S2 RLP-14B (I) S4 RLP-14B (I) FS SB-10 Maximum Speed Side • Side Panel • Rear Panel • Rear Panel • Rear Panel • Rear Panel • Rear Panel • Rear Panel • Rear Panel • Rear 500 rpm 500 rpm 2000 rpm 500 rpm 800 rpm 1500 rpm 800 rpm 300 rpm 1500 rpm Preset Digits All digits except lowest digit All digits except lowest digit All digits except lowest digit All digits except lowest digit All digits except lowest digit All digits except lowest digit All digits except lowest digit All digits except lowest digit 5 digits 6.2 × 4.5mm 6.2 × 4.5mm 8.0 × 5.5mm 8.0 × 5.5mm 8.0 × 5.5mm 8.0 × 5.5mm 8.0 × 5.5mm 8.0 × 5.5mm 6.0 × 3.5mm Mounting • Shaft Position SPECIFICATIONS