LIGHT FIDELITY (LI-FI) TECHNOLOGY AKHIL S S7 CSE 02 MBCET
LIGHT FIDELITY (LI-FI) TECHNOLOGY
AKHIL SS7 CSE 02
MBCET
CONTENTSж ISSUES REGARDING RADIO SPECTRUMж INTRODUCTIONж PRINCIPLE OF LI-FI TECHNOLOGYж VISIBLE LIGHT COMMUNICATIONж CONSTRUCTION and WORKING OF Li-Fiж COMPARISON BETWEEN LI-FI AND WI-FIж FUTURE APPLICATIONSж CHALLENGES FOR LI-FIж CONCLUSIONж REFERENCES
ISSUES REGARDING THE USE OF RADIO SPECTRUM
CAPACITY
EFFICIENCY SECURITY
AVAILABILITY
ж Light–Fidelity (Li-Fi) technology came into existence in 2011.
ж The term was f irst used by Harald Haas in his TED Global talk on Visible Light Communication.
ж In October 2011 a number of companies and industry groups formed the Li-Fi consortium, to promote high-speed optical wireless systems.
ж Researchers at the Heinrich Hertz Institute in Berlin, Germany, have reached data rates of over 500 megabytes per second using a standard white-light LED.
INTRODUCTION
INTRODUCTION (contd..)
ж It allows wireless communication without the use of radio waves, which can be dangerous in places like oil platforms, underwater and on planes
ж Li-Fi can be thought of as a light-based Wi-Fi.
HARALD HAAS
PRINCIPLE OF LI-FI TECHNOLOGYж Heart of Li-Fi technology is high brightness
LED’s.ж The LED bulb will hold a micro-chip that will
do the job of processing the data.ж The on-off activity of LEDs enables a kind of
data transmission using binary codes.ж Switching on an LED is a logical
‘1’;switching it off is a logical ‘0’.ж A light sensitive device (photo detector)
receives the signal and converts it back into original data.
fig(i)..Sending of data [2]
VISIBLE LIGHT COMMUNICATIONж Li-Fi is a faster and cheaper version of Wi-
Fi, which is based on visible light communication (VLC).
ж The visible light communication is a data communication technique using visible light between 400 THz and 800 THz as an optical carrier for data transmission.
WHY VLC ?
ж Gama rays,X-rays,Ultraviolet rays are harmful for the human body.
ж Infrared rays are also dangerous, due to eye safety regulation, and can only be used with low power.
ж Radio waves are expensive and they are less secure.
HENCE WE ARE LEFT WITH ONLY THE VISIBLE - LIGHT SPECTRUM which is not harmful for humans .
Radio Waves
Infrared Rays
Visible Rays
Ultraviolet Rays X- Rays Gama
Rays
Devices used in visible light communication
ж Devices which are used for transmission purpose in VLC are visible light LED and fluorescent lamp.
ж This technology uses fluorescent lamps to transmit signals at 10bit/s, or LED’s for up to 500 Mbit/s.
ж Devices which are used for reception purpose in visible light communication are photo diodes and image sensors.
CONSTRUCTION and WORKING OF Li-Fi
ж Li-Fi is implemented using white LED light bulbs at downlink transmitter.
ж By fast variations of the current, optical output can be made to vary at extremely high speeds.
ж An overhead lamp fitted with an LED with signal processing technology streams data embedded in its beam at ultra high speeds to the photodiodes.
ж A receiver dongle then converts the tiny changes in amplitude into an electrical signal, which is then converted back into a data stream & transmitted to a computer or mobile device.
fig(ii)..Working of Li-Fi [1]
fig(iii)..Illustration of data transfer in Li-Fi [3]
COMPARISON BETWEEN LI-FI AND WI-FISl.No Parameters Light Fidelity Wireless Fidelity
1 Speed for data transfer Faster transfer speed (>1 Gbps) Data Transfer speed (150 Mbps)
2 Medium through whichdata transfers occurs
Used Light as a carrier Used Radio spectrum
3 Spectrum Range Visible light spectrum has 10,000 timebroad spectrum in comparison to radio frequency
Radio frequency spectrum range isless than visible light spectrum.
4 Cost Cheaper than Wi-Fi because free banddoesn’t need license and it use light.
Expensive in comparison to Li-Fibecause its uses radio spectrum.
5 Network topology Point to point Point to point
6 Operating frequency Hundreds of Tera Hz (THz) 2.4 GHz
FUTURE APPLICATIONS
ж Li-Fi can be used in sensitive areas such as aircraft for data transmission without causing interference.
ж It can be used in places where it is difficult to lay optical fibres like operation theaters .
ж In traffic scenario, Li-Fi can be used to communicate with the LED lights of cars and might alert drivers when other vehicles are too close so accident numbers can be decreased.
ж It will improve conditions for those working in underwater oil rigs where radio waves can’t propagate.
FUTURE APPLICATIONS(contd..)
ж Thousands and millions of street lamps can be transferred to Li-Fi lamps to transfer data.
ж It can be used in petroleum and chemical plants where other transmission or frequencies could be hazardous.
CHALLENGES FOR LI-FI
ж Presence of Light is essential.ж Li-Fi requires line of sight.ж It is easily blocked by somebody simply
walking in front of LED source.ж The grand vision: “LED lights with added
microchips will let us transmit thousands of data streams in parallel, enabling us to access the Internet on smartphones wherever there is a light source”.[1]
CONCLUSION
ж Researchers are developing micron sized LED .ж 1000 micron sized LED can fit into area required
by 1sq. mm large single LED. ж A 1 sq.mm sized array of micron sized LED’s
could therefore communicate 1000×1000 (i.e. a million) times as much information as a single 1mm LED.
ж Li-Fi consortium believes it is possible to achieve more than 10Gbps, theoretically allowing a high definition film to be downloaded in 30 seconds.
REFERENCES[1] NEW EPOCH OF WIRELESS COMMUNICATION: LIGHT FIDELITYAuthors: Megha Goyal, Dimple Saproo, Asha Bhagarshra,Journal: International Journal of Innovative Research in Computer and Communication Engineering ISSN/EISSN: 23209798 23209801 Year:2013 Volume: 1 Issue: 2 http://ijircce.com/upload/2013/april/52_New%20Epoch.pdf[2] Li-Fi (Light Fidelity)-The future technology In Wireless communicationhttp://www.ripublication.com/ijaer.htm[3] 'Li-Fi' provides a light bulb moment for wireless web - CNN.com
ANY QUERIES..??
?