LeFebure TA-10 PM and Overhaul Tips BrainWaveTech All Rights Reserved 2010 LeFebure TA-10 PM & Overhaul TIPS Key #0915 1) The Kiosk door should never be lubricated and only cleaned with scotch bright pad. (The Teller terminal can be sprayed with Triflow at the base only) 2) The plunger Switch shaft and Brass Bearing Assembly are the major cause of service calls and should be removed and cleaned completely (or replaced) with a scotch brite pad and never lubricated. (Oil Impregnated Bearings See optional Torch Burn off Page 3) 3) The Pressure sensor should be replaced Yearly or at least every Year and a Half. (due to moisture dry climate's do better, Cannot be cleaned) 4) The Kiosk door switches, plunger switch and call and send switches should be replaced every three years. 5) The wires on the blower contractor should be moved every year to a new location. (there are 3) 6) 7) The Teller door and Kiosk Door relays on the main logic board should be swapped with the Mute and Delay relays every two years. (all relays the Same)
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
LeFebure TA-10 PM and Overhaul Tips BrainWaveTech All Rights Reserved 2010
LeFebure TA-10 PM & Overhaul TIPS Key #0915
1) The Kiosk door should never be lubricated and only cleaned with scotch bright pad.(The Teller terminal can be sprayed with Triflow at the base only)
2) The plunger Switch shaft and Brass Bearing Assembly are the major cause of service calls and should be removed and cleaned completely (or replaced) with a scotch brite pad and never lubricated. (Oil Impregnated Bearings See optional Torch Burn off Page 3)
3) The Pressure sensor should be replaced Yearly or at least every Year and a Half. (due to moisture dry climate's do better, Cannot be cleaned)
4) The Kiosk door switches, plunger switch and call and send switches should be replaced every three years.
5) The wires on the blower contractor should be moved every year to a new location. (there are 3)
6)7) The Teller door and Kiosk Door relays on the main logic board should be
swapped with the Mute and Delay relays every two years. (all relays the Same)
LeFebure TA-10 PM and Overhaul Tips BrainWaveTech All Rights Reserved 2010
Tip: Auto Send BackShorting 11 and 17 on the Main 18 Pin Molex with simulate the Send button being pressed at the Teller terminal
LeFebure TA-10 PM and Overhaul Tips BrainWaveTech All Rights Reserved 2010
OIL IMPREGNATED Bearings Burned out oil by Torch
LeFebure TA-10 PM and Overhaul Tips BrainWaveTech All Rights Reserved 2010
Get Parts From GreenBrier 3046456263
Description
Lefebure Part Number
Seal (door top) Seal (door side, 2 required) Belt, drive (customer door) Switch w/lever (door open/close) Plunger switch (carrier arrival) Wear ring (for cust. door bottom) Blower motor [1] Valve assembly (on blower) Lock for key #0915 Key #0915 Clutch/pulley assy Receiver top (round collar) Cord (neoprene) Motor (door) Cap, AC 125V (Kiosk and Teller door motor) Pressure sensor kit (hose and switch) Swivel, 90° (pressure switch hose conn)