Keep tightly closed when in operation not exceed the rated operating temperature of the fixture. Do not install in a hazardous atmosphere, except where the ambient temperature does Make sure the supply voltage is the same as the rated voltage of the luminaire. Make sure LEDs and drivers are cool to touch when performing maintenance. Minimum size 18 AWG or 14 AWG for continuous runs. Use only UL (or other NTRL) approved wire for input/output connections. Turn off electrical power before inspection, installation or removal. in accordance with the NEC (National Electric Code) and all local codes. This product should be installed, inspected, and maintained by a qualified electrician only, Installation Guide Read and follow all safety instructions WARNING RISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK Electrical Requirements Prepare Electrical Wiring Grounding Instructions SAVE THESE INSTRUCTIONS BEFORE YOU BEGIN The LED driver must be suplied with 120 or 277V, 50/60 Hz and connected to an individual, properly grounded branch circuit protected by a 20 ampere circuit breaker. Use min. 75°C supply. The grounding and bonding of the overall system shall be done in accordance with NEC Article 600 and local codes LED Lighting Fixture