KTM SMR 450 S U P P L E M E N T A R Y M A N U A L

Secure the bike on a stand.

www.healtech-electronics.com

for iQSE-2 + QSH-CKP

PAGE 1/3

left and right side plastic covers.

Remove the

Remove the the fuel tank.

KTM SMR 450 (2004-2007)

S U P P L E M E N T A R Y M A N U A L

www.healtech-electronics.com PAGE 2/3

Also connect the ignition coil ground terminal to the battery

negative terminal.

Connect the QSH black wire terminal to the ignition coil

ground terminal.

S U P P L E M E N T A R Y M A N U A Lfor iQSE-2 + QSH-CKP

KTM SMR 450 (2004-2007)

Connect the two QSH Green wires to the two wires of the

crankshaft position sensor (CKP).

(2-pole, blue connector with red and green wires.)

Connect the qsh red wire tothe battery positive terminal

via an on/off switch.

www.healtech-electronics.com PAGE 3/3

Typical position for theQuickShifter easy.

Secure the unit Properly.

S U P P L E M E N T A R Y M A N U A Lfor iQSE-2 + QSH-CKP

KTM SMR 450 (2004-2007)

a torque wrench, tighten the bolt until the shift arm is tight on the gearbox shaft.)

Mount the QSE sensor under the bolt of gearbox shaft.

sensor like this: (0). Tighten the bolt in this position by about 6 Nm. If you do not have

(Replace the bolt with the one supplied. Place the conical washers at the two sides of the