Watch your fingers when adjusting clamps. They may become pinched resulting in injury. Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers. Before assembly, please make sure that all the items listed below are present. Caution ! Inside This Package Assembly 5 Assembly 6 Side Arm(L1) Side Arm(R) 7 8 9 11 10 Side Arm( ) R 13 14 12 Center Pipe(1) 3 3 Center Pipe(2) Tighten the screw Tighten the screw Tighten the screw 4 4 Tighten the screw Center Pipe(1) Center Pipe(2) 1 2 KT4 ASSEMBLY INSTRUCTIONS Hi-Hat Stand Center Pipe(1) Center Pipe(2) Side Arm(L1) Side Arm(R) [DRUM MODULE] BOX Module Kick Pad [ ] BOX KICK PAD [Hi-Hat Stand] BOX 11” Drum Pad x 4 12" Cymbal Pads x 2 14" Cymbal Padx1 [11” DRUM PADS] BOX [14" CYMBAL PAD] BOX [12" CYMBAL PADS] BOX DRUM RACK Snare pad arm(L2) snare pad arm(L2) 1 Setting up the [1] Attach the Center Pipe(1) to the clamp on the pillar(L1) [2] Attach the Center Pipe(2) to the clamp on the pillar(L1) [3] Attach the Center Pipe(1)(2) to the clamp on the pillar(R1) [4] Using the wing nut tighten the screws on the clamp. [5] Attach the side arm (L1) to the clamp on the pillar(L2) [6] Tighten the screws on the clamp. [7] Attach the side arm (R) to the clamp on the pillar(R2) [8] Tighten the screws on the clamp. [9] Attach the side arm(L1) to the clamp on the pillar(L1) [10] Tighten the screws on the clamp. [11] Attach the side arm(R) to the clamp on the pillar(R1) [12] Tighten the screws on the clamp. [13] Attach the (L2) to the clamp on the pillar(L1) [14] Tighten the screws on the clamp. KT4 drum rack front left vertical front left vertical front right vertical back left side vertical back right side vertical front left vertical front right vertical snare pad arm front left vertical Pillar(L1) Pillar(R1) Pillar(L2) Pillar(R2) Pillar(L2) Pillar(R2) Pillar(L1) Pillar(L2) Pillar(R1) Pillar(L1) Pillar(R1) Pillar(L1) Setup Manual Owner’s Manual Drumsticks X 2 AC Adapter Connection Cables Hexagon Key (M5) L-Rod of Tom3 Boom drum Arm of Tom3 ACCESSORY BOX Boom Cymbal Arms X 3 Drum Key Tennis ball beater Cable Tie wraps X 8 Foot Cable for crash Hand Screws X 2 L-Rods of Pads X 3 12" Hi-Hat Cymbal Pad x 1 [12” BOX Hi-Hat] Hi-Hat Controller Cymbal Clutch Power Cable - Y type Hi-Hat cup Felt SD Card