KSW LightsaberWrapSet Papercraft

Lightsabers

Lightsaber Instructions1. Print at 100% (do not scale down) and cut out the hilt you want to use.

2. For Yoda’s lightsaber shoto: Glue or tape hilt around an empty toilet paper roll.

3. For the generic Jedi’s lightsaber: Glue or tape hilt around an empty paper towel roll.

4. For Darth Maul’s double-bladed lightsaber: Use clear tape or duct tape to connect two paper towel rolls end to end. Then glue or tape hilt around the connected paper towel rolls.

STAR WARS™ and © 2012 Lucasfi lm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.

STAR WARS™ and © 2012 Lucasfi lm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.

YODA’S LIGHTSABER

HANDLE

BEAM END

GLUE

STAR WARS™ and © 2012 Lucasfi lm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.

JEDI’S LIGHTSABER

HANDLE

BEAM END

GLU

E

STAR WARS™ and © 2012 Lucasfi lm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.

DARTH MAUL’S DOUBLE-BLADED LIGHTSABER (1 of 2)

CONNECT WITH OTHER END

BEAM END

GLU

E

STAR WARS™ and © 2012 Lucasfi lm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.

DARTH MAUL’S DOUBLE-BLADED LIGHTSABER (2 of 2)

CONNECT WITH OTHER END

BEAM END

GLU

E