KLH Speaker Tweeter and Driver Replacement · KLH Speaker Tweeter and Driver Replacement Replace the tweeter and driver of a KLH bookshelf speaker. Written By: Mark Lee Hensley KLH

KLH Speaker Tweeter and Driver ReplacementReplace the tweeter and driver of a KLH bookshelf speaker.

Written By: Mark Lee Hensley

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

Use this guide to replace the tweeter and driver of your KLH bookshelf speaker.

TOOLS:Phillips #2 Screwdriver (1)

Flathead Screwdriver or sudger (1)

Phillips #1 Screwdriver (1)

8" Needle Nose Plier (1)

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

Step 1 — Tweeter and Driver

Remove the front speaker mesh, toexpose the speakers. The mesh willlift off without the use of tools.

Step 2

Once mesh is removed, begin toremove the screws securing thesmall upper speaker/tweeter with a#1 Philips head screwdriver.

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Once the screws have been removed, begin to remove the small upper speaker. To do this, pry itout with either a flateblade screwdriver or sudger.

Take care to not damage the speekers wooden body, whilst prying the speaker out.

Step 4

After you have removed thespeaker, disconnect the Red andBrown wires, from the speaker.

You might require needlenose pliersto do this.

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5

Remove the speaker from its plastic bezel. To do this you'll require a #1 Philips head screwdriver.

Step 6

For the larger bottom speaker, thesame steps will be taken to removethe speaker.

Remove the four screws securingthe speaker.

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

To reassemble your device, follow these instructions in reverse order.

Step 7

Once the screws are removed, to remove the speaker you'll either have to pry it out or push it outfrom underneath the boxes frame.

Step 8

Once the speaker is removed, remove the Black and White wires.

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

This document was last generated on 2017-07-27 12:18:41 AM.

KLH Speaker Tweeter and Driver Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7