Jaguar F-Pace Running Boards / Side Steps Fitting Guide Rover Range Rover... · Jaguar F-Pace Running Boards / Side Steps Fitting Guide Please check all of the fixings you have received.

Jaguar F-PaceRunning Boards / Side Steps Fitting Guide

1: Parts List

Jaguar F-Pace Running Boards / Side Steps Fitting Guide

Please check all of the fixings you have received. If you think you are missing any of the components in the list above, please contact Direct 4x4 for further advice.

Large Washer 4

Large Spring Washer 4

Large Nut 2

T-Bolt 2

Threaded Plate (With Tail) 2

Small Bolt 8

Small Washer 16

Spring Washer 10

Part Name Quantity

Running Board 2

Front Bracket 2

Rear Bracket 2

Large Bolt 2

Small Nut 8


2: Removing the undertray.

To remove the undertray, you will need to undo the screws that are located all around the undertray.

Before attempting to fit the brackets, the undertray (or shield) will need to be removed.

There are 3 sections of the shield, Middle, Left & Right.


3: Fitting the brackets.

3.1: The Front Brackets

The upright at the end of the bracket fits into a hole in the chassis under the tray.A small hole needs to be cut out to allow the T-Bolt to drop down and fix to the bracket.

The 2nd (Wider) upright is attached to the sill using the small bolts, washers, spring washers and nuts.


3: Fitting the brackets.

3.2: The Rear Bracket

The sill fitting of the rear bracket fits in the same as the front. However, the tray needs to be cut to allow the bracket to fit.This can be done with either an angle grinder or dia cutter.

The Threaded Plate (With Tail) is placed into the exposed hole in the chassis. The bolt then goes through the bracket into the plate. (This hole will be covered up once


4: Replacing the undertray.

To refit the undertray, you will need to replace the screws that are located all around the undertray.


4: Fitting the Boards.

You will need to loosen 4 of the 6 bolts and the board and move these down the channel to the bracket. Once the holes are lined up, place the board on the brackets at a 45° angle to allow the board to slip under the sill before pressing the front down.

We recommend that you place the rubber seal behind the sill, not only does this look better, but it also reduces the muck and dirt getting through giving you a cleaner car.

General care and maintenance

Cleaning:

You can use most cleaning products on the steps. We do advise that you avoid any corrosive cleaning solutions. These may include TFR or similar (brake stripping/ cleaning) chemicals, or petrol based solutions (showroom shine or similar). They will tarnish or corrode parts of the steps.When cleaning under the steps, be mindful of any sharp edges at the ends where the aluminium box section finishes.To maintain the life of the steps, we advise you occasionally clean the brackets (or what part of the brackets you can access).

Maintenance:

We advise you to check under the car at several intervals after the initial fitting.1 Week – Check and tighten any bolts after the 1st week of use6 Months – It is advantageous to check the bolts after this period.


Jaguar F-Pace Running Boards / Side Steps Fitting Guide Rover Range Rover... · Jaguar F-Pace Running Boards / Side Steps Fitting Guide Please check all of the fixings you have received.

Documents