iPhone 6 Plus Rear Facing Camera Replacement · iPhone 6 Plus Rear Facing Camera Replacement Replace the Rear Facing Camera in your iPhone 6 Plus. Written By: Walter Galan iPhone
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
iPhone 6 Plus Rear Facing CameraReplacement
Replace the Rear Facing Camera in your iPhone 6 Plus.
Written By: Walter Galan
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
The next two steps demonstrate using the iSclack, a great tool for safely opening the iPhone 6Plus that we recommend for anyone doing more than one repair. If you aren't using the iSclack,skip down two steps.
If the plastic depth gauge is attached at the center of the iSclack, remove it now—it's not neededfor larger phones like the iPhone 6 Plus.
Close the handle on the iSclack, opening the suction cup jaws.
Place the bottom of your iPhone in between the suction cups.
Position the iSclack's upper suction cup against the display, near the home button.
Open the handles to close the jaws of the iSclack. Center the suction cups and press them firmlyonto the top and bottom of the iPhone.
If your display or back glass is badly cracked, covering it with a layer of clear packing tape mayhelp the suction cups adhere. The iSclack also includes two pieces of tape for this purpose.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
If you don't have an iSclack, use asingle suction cup to lift the frontpanel:
Press a suction cup onto thescreen, just above the homebutton.
Be sure the cup is pressedsecurely onto the screen to get atight seal.
If your display is badly cracked,covering it with a layer of clearpacking tape may allow thesuction cup to adhere.Alternatively, very strong tapemay be used instead of thesuction cup. If all else fails, youcan superglue the suction cup tothe broken screen.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
While holding the iPhone down withone hand, pull up on the suction cupto slightly separate the front panelassembly from the rear case.
Take your time and apply firm,constant force. The displayassembly is a much tighter fitthan most devices.
Using a plastic opening tool, beginto gently pry the rear case down,away from the display assembly,while continuing to pull up with thesuction cup.
There are several clips attaching thefront panel assembly to the rearcase, so you may need to use acombination of the suction cup andplastic opening tool to free the frontpanel assembly.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
Several clips along the top edge of the front panel form a partial hinge, allowing the front panelassembly to swing open like a book.
During reassembly, align the clips just below the top edge of the rear case. Then, slide the frontpanel upward until its top edge is flush with that of the rear case.
Step 9
Remove the following Phillipsscrews from the battery connectorbracket:
One 2.3 mm screw
One 3.1 mm screw
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
Remove the metal battery connectorbracket from the iPhone.
Step 11
Use a clean fingernail or the edge ofan opening tool to gently pry thebattery connector up from its socketon the logic board.
Take care to only pry up on thebattery connector, and not thesocket on the logic board. If you pryup on the logic board socket, youmay break the connector entirely.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
In the next four steps, take care to pry up only on the cable connectors, and not on their socketson the logic board.
While still supporting the front panel, use a fingernail or the edge of an opening tool to disconnectthe front-facing camera and earpiece speaker connector.
Step 15
Disconnect the home button cable connector.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
Make sure the battery is disconnected before you disconnect or reconnect the cable in this step.
Use a plastic opening tool to disconnect the display data cable connector.
When reassembling your phone, the display data cable may pop off the connector. This can resultin white lines or a blank screen when powering your phone back on. If that happens, simplyreconnect the cable and power cycle your phone. The best way to power cycle your phone is todisconnect and reconnect the battery connector.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).
Finally, disconnect the digitizer cable connector.
When reconnecting the digitizer cable, do not press the center of the connector. Press one endof the connector, then press the opposite end. Pressing in the center of the connector can bend thecomponent and cause digitizer damage.
Step 18
Remove the front panel assemblyfrom the rear case.
iPhone 6 Plus Rear Facing Camera Repla… Draft: 2018-10-18Guide ID: 29784 -
This document was generated on 2020-11-15 04:53:22 AM (MST).