Introduction to networking (Yarnfield) IP addresses.

Introduction to networking(Yarnfield)

IP addresses

Objectives Define an IP address Describe IP address classes Describe network and host portions of an

address Describe what a broadcast address is used for Describe what private IP addresses are used

for

The Internet Protocol Every machine MUST have a unique address

This is referred to as the IP address This address is used to route packets of

information using TCP/IP to a specific machine The address is made up of two parts a network

address and a host address To find your IP address type ‘ipconfig’ into a

command line window

The network part of the address Is used to route the packet to the correct

network i.e. 194.66.170 would direct the packet to one part of

the Staffordshire university network Once the packet is within the network

The host part of the IP address is important to direct the packet to actual machine within that network

The network address size changes depending on the size of network in which the host is connected. Class A, B, and C

All network addresses are issued by InterNIC (http://www.internic.net/) to ensure that all address attached to the Internet are unique

Host addresses

Address representation (IP v4) An IP address is a 32 bit value

In theory this gives over 4 billion possible addresses In reality the actual number of available addresses is a

lot less than this An IP address is represented by dotted decimal

numbers In reality within the network the values are represented

by binary As humans we do not use binary, as these are

difficult for us to remember Also it is very easy with a large number sequence to

make mistakes when setting the IP address

Address classes

Address 127.*.*.* is a reserved address to indicate loop back i.e. communicate with the device sending the

request

Address classes

Address classes

Broadcast address Is an IP address which is used when

communications are required with ALL of the devices with a certain network address This value is 255 in the host part of the address

Private IP addresses A number of IP addresses have been reserved

for private use on local LANS If you setup a Microsoft windows network it will

default to a class C private network IP address

Subnets Subnets allow for a host part of a host address

to indicate a subnet These are smaller local networks within the major

network The advantage is that this allows a packet to be

more tightly direct to a host The disadvantage is valuable host addresses are

used to create a subnet More details about subnets will be given during the

course

Subnet address Also 32 bits in length Indicates which part of the IP address is the

network, and which part is the host Each class has a default subnet mask Class A - 255.0.0.0 Class B - 255.255.0.0 Class C - 255.255.255.0 Example

192.5.5.35 255.255.255.224 192.5.5.35/27

You cannot skip bits!

Exercise1. What are the two parts that make up an IP

address?2. What are the five classes of IP address, and

which ones can be commercially used?3. For an IPv4 IP address, how many bits are

used and what is the total amount of addresses that can be derived?

4. What is the purpose of a subnet?5. What will a broadcast IP address actually do?

Summary IP addresses are used to route packets of data

throughout a network IPv4 uses 32 bits Hierarchical in nature Classes are A, B, C, D and E Classes A, B and C are used commercially Broadcast addresses reach all host machines

on a network

Questions... ...are there any?