Instructions for rear Rhino Dust Guard Mounted on J Strong Rhino Top with lights Parts List: 1 Rear clear view panel 1 Plastic mount x 36” 10 7 7/16th screws 4 yards Velcro Tools Needed: 1- Phillips screw driver Toll Free 1-877-444-4147 www.Jstrongindustries.com Installation Instructions: Step 1: From rear of Rhino, test fit rear dust guard by aligning protective patches with seat belt brackets. (see fig 1) Step 2: Attach plastic mounting strip to top with 10 7/16th screws provided. (see fig 2) Step 3: Before supplied Velcro can be installed you must clean down the corresponding roll bars with supplied alcohol cleaning pads. Step 4: Install supplied Velcro on each side of the rear roll cage bars to corresponding Velcro mate on dust cover. Step 5 Lube plastic mounting strip with dishwashing liquid or soap and slide rear panel thru strip. Step 6: Fasten Velcro straps on each side. (fig 3) Step 7: Attach dust guard to installed adhesive backed Velcro on the rear roll cage bars. Step 8: Install additional Velcro as needed across the bottom of the rear panel. Note: Rear dust guard will fasten directly to JStrong Industries top without use of adhesive backed Velcro across top section. *Remove rear dust guard completely prior to transporting on highways were speeds may exceed 55 mph *Your new rear dust guard is mad of the highest quality clear plastic. It will, however; scratch if not handled correctly *Use Mild soap and water only to clean all surfaces. Fig 1 Fig 2 Fig 3