SPECIFICATION: Lamp type: LED Output: 1100lm / 2000lm nominal. Colour: 4000°K - Ra80 (830/840) Materials: Body: RAL 9003 White painted mild steel Reflector: RAL 9003 White painted/Specular Aluminium Diffuser: Polycarbonate (OPAL) Control gear: Fixed output / Dali Emergency: Integral 3hr / COMEPS Supply: 240v 50Hz AC Ambient Temperature: 0-25°C Terminal block type: Push-wire (non-EM) / piano-key (EM) Ingress protection: IP20 Whitecroft Lighting Limited Burlington Street, Ashton-under-Lyne, Lancashire OL7 0AX Telephone +44 (0)870 5 087 087 Facsimile: +44 (0)870 5 084 210 Registered No. 3848973 England Registered Office: As above GENERAL INFORMATION A qualified electrician, in accordance with IEE wiring regulations should carry out connection to mains wiring. Observe ESD precautions during installation. This unit must be EARTHED. Ensure that the rated voltage and frequency requirements are compatible with the available mains supply. Cleaning of reflectors and lenses should be carried out using clean, soft and lint free cloths and anti-static cleaning fluid Do not carry out high voltage insulation test, i.e. 500/1000v this may damage internal components. FURTHER INFORMATION TECHNICAL SUPPORT Telephone: 0161 331 5700 E-mail: [email protected]http://www.whitecroftlighting.com/ 1. 2. 3. 4. 5. 6. Installation sheet Harrier PK/HRINSTALLEAF June 2016 - Rev B
5
Embed
Installation sheet Harrier - Whitecroft Lighting...HARRIER Whitecroft Lighting Limited WARNING! The LEDs in this luminaire operate at HIGH VOLTAGE. Ensure that the luminaire is isolated.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
SPECIFICATION:Lamp type: LED
Output: 1100lm / 2000lm nominal.
Colour: 4000°K - Ra80 (830/840)
Materials:
Body: RAL 9003 White painted mild steel
Reflector: RAL 9003 White painted/Specular Aluminium
Registered No. 3848973 England Registered Office: As above
GENERAL INFORMATIONA qualified electrician, in accordance with IEE wiring regulations should carry out connection
to mains wiring.Observe ESD precautions during installation.This unit must be EARTHED.Ensure that the rated voltage and frequency requirements are compatible with the available
mains supply.Cleaning of reflectors and lenses should be carried out using clean, soft and lint free cloths
and anti-static cleaning fluidDo not carry out high voltage insulation test, i.e. 500/1000v this may damage internal