429J6 DCC . INSTAllATION INSTRUCTIONS MS KM-175 93 Master Solenoid Kit FITS KM-175, -176 It -177 Series FOR F4A21-1, F4A22-2, F4A23-2 '93-up Mitsubishi and Chrysler EPC & DCC 42930 Shift 1. To Remove: Disconnect the negative battery cable, draintheATF out of unit, and remove the pan. 2. Remove the transmission filter. Notelengthofbolts. 3. Remove solenoid wiringharness case plugfrom case. Remove ten (10)valvebodybolts, noting the different length bolts: 20mm, 28mm and 45mm. 9. Make sure theo-ring is still on the upper surface ofthe valve body, at the placeshown in Figure 1. 10. Reinstall the valvebodyinto the transaxle, then insert the solenoid wiring harness caseplug intothecase. Be surethe notched part ofthe connector is in the proper place. Also,check thatthe lead wire isn't caught between caseandvalve body. 11. Tighten the ten (10)valvebodyboltsto 10 to 11.5 Nm (7.5t08.5ft.lbs.). 12. Install newfilter, tightenfour boltsto 6 to 6.5 Nm (4 to 5 ft. IbS.). 13. Install new oil pan gasket and oil pan, tightenbolts to 10t011.5Nm(7.5t08.5ft.lbs.). 14. Connect the negative battery cable. 15.Fill unitwith ATF withthe engine running and in "PARK", check fluidlevel and leaks. :;ULENUIU , GEAR A tj 1st {jear 2nd Gear 3rd Gear 4th Gear UN OFF OFF ON UN ON OFF OFF 4. Remove valve body. Themanual valvecan come out- be careful not to drop it. 5. Remove solenoids fromvalvebody, cutwiresfrom old solenoid as close to metalbaseas possible. Label the solenoid wire locations to matchcorrect solenoid wiresback to the original solenoid positions (Figure 1). 6.To Install: Attach blackground wirewith eyelet to the same bolt that was used originally. Cutoriginal grounding wirefromOEMeyelet. 7. Stripbackleadwirescutfromthe old solenoid and original solenoid harness approximately 1/2" and twistbraided wire to forma tightstrand.Loosen the Posi-LockTM Connectors. Insert the bare wire intothe connector until it bottoms out. Tighten the connector. Repeat Ihisprocedure for all of the connections (Figure 1). 8. Install the newsolenoids on the valve body. Place overthe opening, insert solenoid bolts through the valvebody and intothreaded holesof solenoid housing. Start bothboltsbyhand,thentighten to 10 to 11.5 Nm(7.5to 8.5ft. Ibs.).