Installation instructions Monza 5-point-harness The first step is to attach the crotch strap: To do so, fold the backrest backwards (if installed, remove the back stabilisers). Afterwards, the belt side without buckle (marked with arrows in the second picture) is inserted between the backrest and seat (see third picture). Then place this end of the belt centrally under the seat. (1. fully fitted belt in the car seat) (2. crotch strap) (3. Gap between backrest and seat.) Backrest Seat
6
Embed
Installation instructions Monza 5-point-harness harness.pdf · Installation instructions Monza 5-point-harness The first step is to attach the crotch strap: To do so, fold the backrest
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Installation instructions Monza 5-point-harness
The first step is to attach the crotch strap:
To do so, fold the backrest backwards (if installed, remove the back stabilisers).
Afterwards, the belt side without buckle (marked with arrows in the second
picture) is inserted between the backrest and seat (see third picture). Then
place this end of the belt centrally under the seat.
(1. fully fitted belt in the car seat) (2. crotch strap)
(3. Gap between backrest and seat.)
Backrest
Seat
Now thread the other side of the strap, which has a buckle, between the fabric
pad and foam (like in the fourth picture). Now pass the buckle under the pad
and pull the short end through the hole in the foam upwards (as shown in the
fifth picture).
1.2.
Now take the long end of the strap which has no buckle and attach the metal
buckle as shown in the pictures below.
2
4
(4. Pull the strap under the cushion) (5. Belt end with buckle and short strap through foam)
1 2
4
2
3
Finally put the two buckles together so that they are centrally under the seat
(see picture).
Now the belt buckle has to be attached:
Guide the short strap which was passed through the foam through the
abduction block. Then they guide the belt through the plastic adjuster from
behind then from the front to the back through the top slit. Now the adjuster
should look like in the picture. Further, pull the belt through the strap in the
belt buckle from the rear.
Then pull the rest of the strap through the adjuster in reverse order. Also the
end has to go through the gap, not like in the picture.
Adjuster
Finally, pull the end through the black plastic adjuster as indicated by the
arrows.
Attach shoulder straps:
2x
The strap end with two eyelets on the headrest screws (screw + nut). For a shorter strap, the lower
eyelet can be used. Then pull the shoulder straps between the headrest and the backrest forward
onto the seat.
Guide the other end of the belt to the side between seat and backrest and