DB-525 Front Panel 5.25 inch Device Bay Installation Guide Step 1 Check the contents of the Box. Front Connect DB-525 metal frame with P.C.B DB-525 plastic cover 1 for HDD DB-525 plastic cover 2 for MO/FDD/Zip Installation guide Screws R NT 2.Insert your DB-525 into the slot, Do not force it in any further than needed. Step 2 Remove the cover case from the computer. Please check that everything connected to the computer has been removed and that the computer itself has been switched off from the main power supply. Please consult the computer manual when remove the cover case from the computer. Caution: Please be careful when removing the cover case as all edges are sharp. 3.Please use the screws provided to lock the DB-525 into place. Step 4 Step 5-2 Step 5-1 Step 5 Connect the FireWire cable. (For IEEE-1394 host adapter with 6pin connector.) Locate the FireWire 6pin-plug cable in the package. Connect the USB 2.0 interface cable. (For built-in internal USB 2.0 or 1.1 connector on mainboard.) Locate A-to-5pin type USB cable in the package. Connect the USB interface cable. (For USB 2.0 host adapter with A-type connector) For built-in internal USB 2.0 or 1.1 connector on mainboard: refer to Step 5-1. For USB 2.0 host adapter with A-type connector: refer to Step 5-2. To connect the USB cable from the main board, please check your mainboard manual and page 2 of this manual for further connection instruction. Caution: The USB port may be damaged if inserting USB flat cable on reverse.(Warranty does not cover such damage) Caution: For easy installation, connect the USB & FireWire cables to DB-525 before insert it into the slot. Step 3 Install DB-525 to the computer. 1.Remove the 5.25-inch panel. Further details on how to remove the panel can be found in your computer NNECT Connect the USB 2.0 or 1.1 interface cable. Internal USB Port Internal IEEE 1394 Port USB Power USB P3- USB P3+ GND USB Power USB P2- USB P2+ GND NC 1 6 ASUS 10 5 Internal USB Port