Model: PF-275 Model# PF-275 INDUSTRIAL GENERATOR MTU DIESEL GENERATOR SETS POWERFORCE ® MTU Detroit Diesel Series Generator Sets for Industrial Applications: POWERFORCE ® industrIal generators are designed to meet the rugged demands of the industrial environment, such as Oil & Gas drilling. Each model has been designed to provide reliable continuous power to typical industrial application electrical loads. All models are extensively tested to ensure they meet the performance requirements of the industry. POWERFORCE ® generators are packaged in a purpose built generator assembly and test facility. Each set goes through a fully documented test procedure before leaving our plant. Industrial models utilize the MTU Diesel engines governed to run at 1800 rpm for long life and durability. All industrial generators are designed and packaged as Prime Power & Standby Rated sets. See ratings below for the prime power & standby kW. Rating Data of Industrial Generators: Specification & Application Data PowerForce ® Corporate Office ▪ 9200 Liberty Drive ▪ Liberty ▪ MO 64068 ▪ Ph 816.781.8070 ▪ Fax 816.781.2207 www.powerforce.com Voltage Ph Starng skVA (30% voltage dip) PF Prime Standby kW kVA kW kVA 277/480 3 TBA 0.8 250 312 275 343 347/600 3 N.A N.A N.A N.A. N.A N.A. Prime - Prime ratings are applicable for supplying continuous power with a 105 ˚ C alternator temperature rise. 10% overload available for 1 hour in 12. Standby - The standby rating is applicable to varying loads for the duration of a power outage. No overload capability for standby rating 130 ˚ C alternator temperature rise Photo depicts a typical POWERFORCE ® open set design but may not include certain options Engine Specificaons Manufacturer MTU Engine Model (Displacement-liters) 6R1600G70S Type Diesel 4-cycle, direct injecon Number of cylinders & arrangement In-line 6 Aspiraon Naturally Aspirated Nominal horse power 418 hp Speed 1800 rpm Radiator ambient rang F° (C°) 122° (55°) Alternator Specificaons Manufacturer Marathon Type Brushless 4-pole Voltages (3 Phase Wye) 277/480 V Power Factor 0.80 Insulaon Class H Winding Temperature Rise (Prime) 130°C Bearing Single-bearing Skid Design Base - structural I-beam Heavy duty powder coated Coupling Direct Drive Starng Voltage 24 V Starter and 70A Alternator Baeries 2-Group 31 Cold cranking amps 950 each Reserve Capacity 34 minutes Starng current amps 1140 Baery enclosure Fully enclosed rail mounted Standard Accessories Fuel Filtraon Engine mounted Air filter System Single Stage replaceable filter Oponal equipment available Block Heater Kim Hotstart 6000W; 7.2A; 480V Starng Air Starter Shutdown Emergency air shut down system Circuit Breaker Supplied to suit applicaon Charging 24 V Automac baery charger Baeries Extra set of baeries with enclosure Exhaust Mild steel with Cowl Silencer