Screen Repair Tutorial How to Fix a HTC Amaze 4G www.StriveMobile.com
Jun 19, 2015
Screen Repair Tutorial
How to Fix a HTC Amaze 4G
www.StriveMobile.com
Things you’ll need
HTC Amaze 4G LCD + Touch Screen Replacement (Fused Screens)
Nylon Spudger
Plastic Pry Tools
Small Phillips Screwdriver
Torx T5 Screwdriver
3M Adhesive Strips
Heat Gun or Hair Dryer
visit www.StriveMobile.com to purchase your DIY kit
Disassembly - Step 1
Power off the device
Remove the back battery cover, battery, Sim card, & SD memory card
Using a Torx T5 screwdriver, remove the seven (7) screws shown in the figure
*Note that these screws are all the same size
Disassembly - Step 2
Use a pry tool or nylon spudger to begin releasing the clips holding the back plastic housing in place
These are held in with clips, so work you way around slowly, releasing each clip until the back housing can fully be removed
Removing the Motherboard
With the motherboard exposed we have three (3) small Phillips screws (#00) to be removed.
The power button flex cable will also need to be released from the front housing. This is held in place with adhesive, gently lift this up and away from the housing.
The final flex cable on the left is a “pop” connector, simply lift this up using a plastic pry tool
Removing the Motherboard
Release this hidden jaw connector – use a pry tool to lift the white tab and remove the flex cable located inside. This is the touch screen flex cable
Removing the Motherboard
You can now flip the motherboard down, exposing two (2) more “jaw” flex cables. Lift the white tab on each connector and remove the flex cables.
Removing the Motherboard
The final step in removing the motherboard will be to release any tape holding the motherboard from the front and releasing this small antenna cable. Use a pry tool and gently lift it up
Heating the Screen Assembly
Using a heat gun or hair dryer we can now heat the two (2) strips of adhesive holding the screen assembly to the front housing. Focus the heat on these two areas for about 30 seconds on medium heat. We also suggest heating the same areas from the front.
Removing the Screen Assembly
With the adhesive properly warmed, use a spudger or pry tool to begin releasing the adhesive holding the LCD screen to the front housing. This process can take some time, stay patient and aim for the two strips of adhesive using any hole available on the back of the housing.
Removing the Screen Assembly
The screen assembly should be fully removed as one piece – the LCD and touch screen digitizer.
Take note of the two (2) pieces of adhesive which held the screen in place.
When swapping out screens, apply new adhesive here if the old adhesive is not sticky
Reassembling the Motherboard
Feed your new LCD flex cable and touch screen flex cable back through the front housing
Once aligned, apply pressure and begin reconnecting the motherboard.
Begin with these two (2) flex cables on the back of the motherboard. Take your time and be sure they are FULLY inserted. Close the jaw connector once complete.
Reassembling the Motherboard
Replace:
The 3 small Phillips screws
Power button back onto the front housing
Touch screen flex cable
Pop connector (on top of touch screen connector)
Antenna cable
Almost done!
Place the back housing onto the device and clip it securely back into place
Screw in all seven (7) Torx T5 screws back into the housing
Replace the battery, sim card, memory card, and battery cover back onto the device
Success!!
And there you have it! Your Amaze 4G is now looking and working like new again!
Don’t forget to visit us at www.StriveMobile.com to order your HTC Amaze 4G LCD + Touch Screen Digitizer Repair Kit!