Howto Fit Rear Electric Windows Fitting the rear electric windows is a lot simpler than people think. There are a couple of fiddly bits which I will try and cover in as much detail as possible and of course there are several parts & tools you will need before you commence. Parts List Passenger side rear electric motor assembly Passenger side rear electric window switch Passenger side door wiring loom with electric motor and switch connectors Drivers side rear electric motor assembly Drivers side rear electric window switch Drivers side door wiring loom with electric motor and switch connectors Drivers door switch panel with rear window controls and isolator switch 2 x Small nuts & bolts (approximately 1.5" long with reasonable size head, bolts should be quite thick as they will take a bit of strain) 4 x Pop rivets (rivet head should be 11mm long x 5 mm wide ish) Short length of spare wire Tools Required T20 & T25 Torx bits & driver Piece of cloth (strong J cloth or duster ideal) Small straight screwdriver Drill with about a 7 or 8mm drill bit Pop Rivet Gun Multimeter (optional but makes life easier) Sharp knife Door pre-stripping. Carefully remove the door handle cover with a straight edge (preferably plastic, but if you're careful you can use a screwdriver don't blame me if you scratch it though). Undo the two screws inside and remove them, also undo and remove the two screws at the very bottom of the door panel holding the panel to the door. Side 1 af 19 Howto Fit Rear Electric Windows - Vectra C / Signum Owners' Club Forums 10-10-2008 http://forum.vectra-c.com/showthread.php?t=53134
19
Embed
Howto Fit Rear Electric Windows - Vectra C / Signum Owners ...danborg.org/opel/elruder.pdf · Howto Fit Rear Electric Windows Fitting the rear electric windows is a lot simpler than
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Howto Fit Rear Electric Windows
Fitting the rear electric windows is a lot simpler than people think. There are a couple of fiddly bits which I will try and
cover in as much detail as possible and of course there are several parts & tools you will need before you commence.
Parts List
Passenger side rear electric motor assembly
Passenger side rear electric window switch
Passenger side door wiring loom with electric motor and switch connectors
Drivers side rear electric motor assembly
Drivers side rear electric window switch
Drivers side door wiring loom with electric motor and switch connectors
Drivers door switch panel with rear window controls and isolator switch
2 x Small nuts & bolts (approximately 1.5" long with reasonable size head, bolts should be quite thick as they will take a
bit of strain)
4 x Pop rivets (rivet head should be 11mm long x 5 mm wide ish)
Short length of spare wire
Tools Required
T20 & T25 Torx bits & driver
Piece of cloth (strong J cloth or duster ideal)
Small straight screwdriver
Drill with about a 7 or 8mm drill bit
Pop Rivet Gun
Multimeter (optional but makes life easier)
Sharp knife
Door pre-stripping.
Carefully remove the door handle cover with a straight edge (preferably plastic, but if you're careful you can use a
screwdriver don't blame me if you scratch it though). Undo the two screws inside and remove them, also undo and
remove the two screws at the very bottom of the door panel holding the panel to the door.
Side 1 af 19Howto Fit Rear Electric Windows - Vectra C / Signum Owners' Club Forums