How To Make Wiki/Tiki Torch Out of Recycled Glass Wine, Beer, Soda Bottles With Clever Wick Holder By TeeDiddlyDee Total Cost for Supplies: $8-$9 Build Time: ½ hour There are many DIY tutorials about this on the web, but I put a little spin to my method with the wick holder. I used to work for a winery and not surprisingly, I’ve got an abundant supply of wine bottles! It seemed like such a waste to just throw away all of those bottles…so this is what I did with them! I also had a few beer bottles on hand thanks to my roommates…I decided to leave the label on for all of you Coors Light fans!
9
Embed
How To Make WikiTiki Torch Out of Recycled Glass Wine ......How To Make Wiki/Tiki Torch Out of Recycled Glass Wine, Beer, Soda Bottles With Clever Wick Holder By TeeDiddlyDee Total
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
How To Make Wiki/Tiki Torch Out of Recycled Glass Wine,
Beer, Soda Bottles With Clever Wick Holder
By TeeDiddlyDee
Total Cost for Supplies: $8$9
Build Time: ½ hour
There are many DIY tutorials about this on the web, but I put a little spin to my method with the wick
holder.
I used to work for a winery and not surprisingly, I’ve got an abundant supply of wine bottles! It seemed
like such a waste to just throw away all of those bottles…so this is what I did with them!
I also had a few beer bottles on hand thanks to my roommates…I decided to leave the label on for all of
you Coors Light fans!
Tools
� Wire Nippers
� Funnel
� Hand Drill
� Pliers
Materials (Besides the bottles, I found everything here at Low’s)
1. One Tiki replacement wick
2. 3/4in x3/4in brass coupling for a PEX pipe (this serves as a clever wick holder)
3. 1/2in copper cap
4. Two hex nuts (threaded for 3/8in16 thread rod)
5. 4 or 5 inches of decorative chain
6. 3/4in split ring hanger (threaded for 3/8in16 thread rod)
7. Two wood screws
8. Top plate connector (threaded for 3/8 in16 thread rod)
9. 4 1/2in long, 3/8in diameter16 zinc plated threaded rod (I bought a 3ft rod and cut into 8
pieces)
10. Tiki torch fuel
11. Empty glass bottle
Important: Bottle opening sizes can vary so you may need to also purchase a 16mm flat washer to
make sure wick holder fits.
To see if you will need the washer or not, take the ¾ x ¾ coupling
And place it right on top of the bottle opening
If opening of bottle is too large for the coupling, place the 16mm flat washer between the bottle
opening and the coupling
Easy!
Now slide tiki wick into wick holder leaving about ¼ 1/2in of the wick sticking out of top
Fill bottle up to neck with Tiki torch fuel and let wick soak up the fuel before lighting!
(I fill my bottles to the VERY top, right below the wick holder because I like a larger flame)