HOOKER FURNITURE COMPLETE BED ASSEMBLY FOR KING OR QUEEN ITEM NUMBER: 454, 464, 754, 764 PAGE 1 OF 6 PRODUCTS ARE NOT INTENDED FOR COMMERCIAL USE. UPDATED 09/2016
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
HOOKER FURNITURE
COMPLETE BED ASSEMBLY FOR KING OR QUEEN
ITEM NUMBER: 454, 464, 754, 764
PAGE 1 OF 6
PRODUCTS ARE NOT INTENDED FOR COMMERCIAL USE. UPDATED 09/2016
8
PAGE 2 OF 6
D 1
Allen Wrench
24
E 2
Letter QTY COMPONENTS
F
G
H
I
J
Support Legs (F)
Supports (G)
Headboard (H)
Side Rails (I)
Footboard (J)
Side Rail Bracket
Screws
Rubber Washers
Joint Connector Bolt
MATT
RESS
SIDE
STEP 1: Attach the side rails (I) to the Footboard (J) by inserting the bolt heads at the end of the Side rails into the brackets on the Footboard. Push down to lock the bolts in place. DO NOT force the Side rails into the brackets.
PAGE 3 OF 6
Before assembling the bed, you must turn the Side Rails (I) to the position you intend to use. If you are using a Mattress-Box Spring combination, see detail (1) below. If you are using a mattress only, see detail (2) below.
DETAIL (1) LEFT SIDE RAIL
DETAIL (2) RIGHT SIDE RAIL
(I) (J)
RAIL IN LOWER POSITION
RAIL IN HIGHER POSITION
STEP 3: Attach the bracket (E) onto the bolts of the plate that is attached to the side rail. Screw the bracket into the headboard with 4 of the Wood Screws (A) provided.
PAGE 4 OF 6
STEP 2: Prop the headboard (H) up against a wall. Carefully move the Footboard Assembly (J & I) From Step 1 to the headboard. Align the holes in the Side Rails (I) with the holes in the wings of the Headboard. Attach the two with the bolts (C) .
(H)
(I)
(C)
(H)
(I) E)
MATTRESS ONLY ASSEMBLY
MATTRESS-BOXPRING ASSEMBLY
PAGE 5 OF 6
STEP 5: For a Mattress-Box Spring combination, remove the upper part of the Support Leg (F) and place Rubber Washers (B) to the bottom section of the leg (F). Screw the Support Legs (F) into the Support (G) making sure the side WITHOUT the metal hardware showing.
STEP 4: If you are using a Mattress-Box Spring combination, skip to STEP 5. Attach the Support Legs (F) and Rubber Washers (B) to the Supports (G) center holes. Screw them into the side WITHOUT the metal hardware showing.
G
(F)
(F)
G
(F)
(F)
STEP 6: Lay the Supports (G) on the Side Rails (I) Support Rails. Evenly space the Supports and then attach the ends to the rails using 2 Screws (A) per end.
PAGE 6 OF 6
(H)
(H)
(G)
(I)
(J)
MATTRESS
SIDE
MATTRESS
SIDE
MATTRESS
SIDE
MATTRESS
SIDE
Related Documents
