https://www.allfasteners.com.au/anchor-rods-cast-in Print Date 02/11/2021 | Page 1 of 2 Whilst every care was taken in preparation of this guide, Allfasteners® accepts no responsibility for the accuracy of the information supplied. Copyright ©2021. The contents of this document are the exclusive copyright of Allfasteners® and may not be reproduced without prior written permission. 1800 255 349 | [email protected] PDS Hold Down Anchor Bolts Hold down bolts (or anchor rods) are a highly versatile product and can be configured in multiple ways included square or round hold down bolt cage assemblies. With several raw bar materials & threaded rods available they can be specified in mild or high tensile steel, or stainless- steel grades from M12 to M42 diameter commonly, or larger on request. Anchor plates can be produced and fitted prior to delivery. Your specified shape plates can be tacked welded in place with nuts if required, or a fully welded. Provided finished usually in pre-galvanised parts, or fully galvanised after fabrication, they can also be produced from 304 and 316 stainless steel if required. Typical rod dimension: Diameter (D) x Length (L) x Plate Position (A) x Thread (T) Typical plate dimension: Width (F) x Length (C) x Plate Thickness (H) Send us your specs download the RFQ sheet from the tab below.