Antiquax Ring Remover removes water and heat mark damage from a range of polished surfaces such as lacquers, varnishes and French Polish. Ring Remover will also restore the gloss and remove minor defects from finishes. DIRECTIONS FOR USE Shake well before use. Pour the Ring Remover onto a lint free cloth and rub with pressure over the mark in the direction of the grain until the mark is removed. If the mark does not disappear apply more Ring Remover and repeat. Buff with Antiquax Polishing Cloth and then wax if required. For deeper marks the Ring Remover can be applied with Fine Steel Wool (grade0000). For satin or matt finishes the same grade of steel wool may be used to matt the surface down after the Ring Remover has been used as it may produce a shiny surface. Test the product on an inconspicuous area to ensure that it is compatible with the surface. Ring Remover Ring Remover HEALTH & SAFETY Contains gum turpentine. May produce an allergic reaction. Keep out of reach of children. Do not get in eyes, on skin, or on clothing. IF SWALLOWED: Call a POISON CENTRE or doctor if you feel unwell. IF ON SKIN: Wash with plenty of soap and water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Wear protective gloves/protective clothing/eye protection/face protection. If skin irritation occurs: Get medical advice/attention. Made in UK Ring Remover Ring Remover