This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
HayssenSandiacre Barry Wehmiller Herman Hayssen 1910
(FFS) 10000 HayssenSandiacre
HayssenSandiacre FFS Ultima® 130
HayssenSandiacre
Nick Caggiano 300 400
HayssenSandiacre Adobe ® FrameMaker® Caggiano
Caggiano Barry Wehmiller SolidWorks® Composer
HAYSSENSANDIACRE SolidWorks Composer
利用 S o l i d W o r k s C o m p o s e r 软件,HayssenSandiacre 可以直接从 3D CAD 模型创建文档影像,加快文档的开发速度。
HayssenSandiacre225 Spartangreen Blvd.Duncan SC 29334 USA
1 864 486 4000www.hayssensandiacre.com
TriMech Solutions Charlotte NC USA
U l t i m a ® X X 9-1/Rev 6HAYSSENSANDIACRE®
9
KNIFE ASSEMBLY
The knife is housed in the front jaw assembly. Operating in an orbital motion, it swings out of a recess in the front jaw, cuts through the film, and passes into a recess in the rear jaw. At the end of the dwell time, the knife retracts back into the front jaw.
Knife Blade Replacement
To remove and reinstall the knife blade, perform the steps outlined in the following diagrams depicting the jaw assembly.
WARNING:Use caution when working in the knife area. The knife edge is extremely sharp and cuts even when brushed against.
WARNING:• Always REMOVE power and air from the machine
before performing the knife blade replacement proce-dure.
• Use appropriate lockout/tagout procedures.
1. 2.
3. 4.
U l t i m a ® X X 9-1/Rev 6HAYSSENSANDIACRE®
9
KNIFE ASSEMBLY
The knife is housed in the front jaw assembly. Operating in an orbital motion, it swings out of a recess in the front jaw, cuts through the film, and passes into a recess in the rear jaw. At the end of the dwell time, the knife retracts back into the front jaw.
Knife Blade Replacement
1. Remove machine power and air.Use appropriate lockout/tagout procedures.
2. Pull front jaw carrier toward the front of the machine.3. Lift the right side knife retainer from the pin4. Swing the knife retainer to the side.5. Lift the left side knife retainer from the pin.6. Swing the knife retainer to the side.
WARNING:Use caution when working in the knife area. The knife edge is extremely sharp and cuts even when brushed against.
1 = Knife Retainer 6 = Flow Control2 = Knife 7 = Knife Air Cylinder3 = Rear Jaw 8 = Jam Nut4 = Knife Linkage 9 = Rod End
5 = Front Jaw
CAUTION:Use caution when working with the knife, as it is very sharp and may be very hot.
21 3
45
67
8
96
使用 SolidWorks Composer 之前
使用 SolidWorks Composer 之后
SolidWorks Composer HayssenSandiacre
Dassault Systèmes SolidWorks Corporation175 Wyman Street Waltham, MA 02451 USA