8/8/2019 Guide to Lacing http://slidepdf.com/reader/full/guide-to-lacing 1/15 GUIDE TO LACING 1. The lace is run straight across the bottom and emerges through both bottom eyelets. 2. The laces then go straight up and are fed into the next set of eyelets up the shoe. 3. The ends are crossed over and are fed under the vertical lace section on the opposite sides of the shoe before going straight up and into the next set of eyelets up the shoe. 4. At the top set of eyelets, the laces can once again cross over and pass under the straight section as shown. This not only looks consistent with the rest of the lacing but also forms a High Lace Lock, which tightens the lacing even more firmly.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
1. The lace is run straight across the bottom and emerges through both bottomeyelets.
2. The laces then go straight up and are fed into the next set of eyelets up the shoe.
3. The ends are crossed over and are fed under the vertical lace section on the
opposite sides of the shoe before going straight up and into the next set of eyelets upthe shoe.
4. At the top set of eyelets, the laces can once again cross over and pass under thestraight section as shown. This not only looks consistent with the rest of the lacingbut also forms a High Lace Lock, which tightens the lacing even more firmly.
1. The lace is run straight across the bottom and emerges through both bottomeyelets.
2. The left (red) end is spiralled up the left side of the shoe, with the end fed underand emerging from each eyelet.
3. The right (orange) lace is spiralled up the right side of the shoe, at each eyeletlooping through the left (blue) lace in the middle of the shoe before feeding under
1. The lace runs straight across the bottom and the ends are fed into both bottomeyelets.
2. One end of the lace (orange end) runs straight up the right side, emerges fromand runs straight across the second set of eyelets.
3. The other end (red end) runs diagonally underneath and, skipping the 2nd set of eyelets, emerges from and runs straight across the 3rd set of eyelets.
4. Continue running each lace diagonally across and up 2 sets of eyelets until oneend (orange in my example) reaches the top right eyelet.
5. The other end (red in my example) then runs straight up the left side to emergefrom the top left eyelet.
1. Take two different colour laces, each a tiny bit longer than the correct length forthe shoes.
2. Cut them not quite in half, but offset by two or three centimetres. See below forhow to calculate the difference in length between the two halves.
3. Tie one shorter piece of one colour (orange in my example) and one longer pieceof the other colour (red in my example) firmly together and trim off the excess. For
extra security, add a dab of glue. Use the remaining pieces to make the bi-colourlace for the other shoe.
4. Pull the longer (red) end out through the bottom right eyelet, feeding from insidethe shoe, until you reach the joining knot.
5. Now lace the rest of the shoe as per Straight (Fashion) Lacing.