Guardian 275® 4” Wall Panel Installation Manual MAJOR INDUSTRIES, INC. / 888-759-2678 / 715-842-4616 / WWW.MAJORSKYLIGHTS.COM Guardian 275® 4” Wall Panel Installation Manual This instructional manual provides “General Installation Instruction.” Installers should refer to the "as-built" shop drawings for specific guidance as it relates to your system. For additional information, contact Major Industries.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Guardian 275® 4” Wall Panel Installation Manual
MAJOR INDUSTRIES, INC. / 888-759-2678 / 715-842-4616 / WWW.MAJORSKYLIGHTS.COM
Guardian 275®
4” Wall Panel
Installation Manual
This instructional manual provides “General Installation Instruction.” Installers should refer to
the "as-built" shop drawings for specific guidance as it relates to your system. For additional
information, contact Major Industries.
Guardian 275® 4” Wall Panel Installation Manual
MAJOR INDUSTRIES, INC. / 888-759-2678 / 715-842-4616 / WWW.MAJORSKYLIGHTS.COM
INTRODUCTION
Quality installation in a timely manner requires
careful attention to planning and detail. We need
your help to ensure a successful weather-tight
installation.
We produce our custom-fabricated daylighting
products to precise dimensions under factory-
controlled conditions. Everything has been checked
and verified to meet shop drawings and the
architectural requirements. Your job is perhaps the
most important step yet to be completed. Our
analysis of warranty claims indicates that over 85%
of all field complaints are the result of improper
installation or - equally damaging - an improper
assembly during installation. All Major Industries
daylighting products are designed as a system - you
must assemble the parts and pieces in exact
sequence. Any effort to “freelance” or do it in a new
way risks our common goal of ensuring weather-
tightness and owner satisfaction.
Finally, our warranty commitment sold with this job
is predicated on satisfactory site conditions. Please
take the time to perform a thorough site audit prior
to starting your installation, and ask yourself the
following questions before installation. If even one
of them is false, you are almost guaranteed to have a
less than optimal installation.
UNLOADING
Unloading should be organized to minimize material
handling. If hoisting is required by either crane or
forklift, the skylight’s weight should be evenly
distributed to prevent distorting or damaging the
material. Use only approved nylon lift slings that are
in good condition and sized to the load. Crates are
for shipping purposes only and should not be relied
upon for hoisting or storage.
INSPECTION
Upon receipt, inspect the shipment to ensure that
materials were not damaged during shipping. If
damage is visible or suspected, note it on the bill of
lading and contact Major Industries as soon as
possible. Count material and check it immediately
against the packing list. If there is a shortage, note it
on the bill of lading and contact Major immediately.
STORAGE
While a single panel easily withstands exposure to
sunlight and the elements, a stack of panels will trap
heat and moisture, causing clouding in the panels.
To avoid this irreversible effect, panels must be
stored in a dry, shaded, well-ventilated area. Skids
should be elevated at one end by wood spacers. It is
the installer’s responsibility to protect materials until
they are installed - unless otherwise specified. When
placing materials on the roof, it is the installer’s
responsibility to make sure roofing materials are not
damaged. Failure to comply with recommended
storage procedures will negatively affect the
warranty on the panels.
INSTALLATION NOTES
Major Industries does not recommend walking on
the panels. If the installer must walk on the panels,
the panel surface MUST be protected by applying a
layer of foam carpet padding over the panel surface,
followed by a sheet of plywood or other similar
smooth material to distribute weight.
It is the installer’s responsibility to correctly install
and seal the entire unit. Always install only a
quantity of panels that can be fully protected with
glazing caps at the end of the day. Glazing panels are
not designed to be left unprotected from the
weather. Water damage during installation is not
covered by warranty. Always remember that water
can be drawn up into the skylight due to negative
interior building pressure. Properly clean all building
surfaces to be caulked with approved cleaning
solutions. Make sure caulking and sealants make
uniform contact with all surfaces being sealed. It is
important that all necessary sealants and caulking
are properly applied. Installers need to verify with
the sealant supplier and manufacturer as to the
proper sealant type required for the application.
Failure to do so may cause the system to fail, causing
possible interior damage.
The installer must have the sign-off sheet (supplied
with the Major Industries purchase order) signed by
the job site superintendent before leaving the job
site. No payments will be released to the contractor
until this sign-off sheet is forwarded to Major.
These instructions have been supplied to assist with
installation. They are correct to the best of our
knowledge - however, no warranty is expressed or
implied. Each installation is unique and attention
must be given to the approved shop drawings
supplied specifically for this project. Any
modifications require factory approval. Major
Guardian 275® 4” Wall Panel Installation Manual
Guardian 275® 4” Wall System Install Manual - Page 3
MAJOR INDUSTRIES, INC. / 715-842-4616 / WWW.MAJORSKYLIGHTS.COM
Industries expects its installers to be knowledgable
and complete all work professionally and to industry
standards.
DAMAGE WARNING
Do not attempt to weld or cut any materials near an
installed skylight or wall system. Damage may occur
to the panel from flames, hot metal or sparks unless
they are fully protected by fireproof material.
We want our installers and customers to have the
best daylighting system possible, and we encourage
you to call us with your questions and concerns.
Major's experienced personnel can troubleshoot the
problem and help you choose the best option.
IF YOU NEED ADDITIONAL INFORMATION,
CONTACT MAJOR AT 888-759-2678.
APPROVED MATERIALS
Cleaning Solutions: Mild Soap & Water, Non-corrosive, Non-abrasive - NO Ammonia, NO Chlorine,