1 THOROUGHLY CLEAN YOUR SCREEN. Turn off your phone and remove any accessories (case, screen protection, etc). Clean your screen thoroughly, even if it just came out of the box. Start with the wet wipe, followed by the microfiber cloth. Pay extra attention to the curved edges. Use the included dust removal sticker to remove any remaining lint or dust. 2 PLACE EZ APPLY TRAY ON PHONE. You must use the install tray to ensure proper alignment. If your InvisibleShield is not on straight, you may have functionality issues. The top of the tray is marked with the InvisibleShield logo and aligns with the speaker end of your phone. Set the EZ Apply tray on top of your device and firmly press down to secure it in place. Check the corners to make sure they are secure and properly aligned. 3 4 REMOVE TAB 1. PEEL AND PLACE. Before you place the InvisibleShield onto the EZ Apply tray, notice that the top of the InvisibleShield has been cut to fit around the speaker of your phone. This end will go at the top of the EZ Apply tray—the end with the InvisibleShield logo. Peel away the clear protective film labelled #1. Do NOT touch the exposed surface. Use the EZ Apply tabs to place the InvisibleShield in the EZ Apply tray. APPLY USING SQUEEGEE. With your finger, press down on the InvisibleShield near the middle of the screen. Then carefully remove the EZ Apply tray and carefully peel away the protective liner. Important: This is a full-adhesive screen protector. The installation process, while not difficult, requires attention to detail. Please allow yourself time to execute each step carefully and thoroughly. glass curve elite Installation tips tip For the next part, hold the squeegee with four fingers when you run it down the length of the screen. This will create firm, steady pressure. Starting at the bottom of the screen, use the fabric end of the squeegee and run it to the top of the screen in one smooth motion. Next, start at the bottom of the screen again and run the squeegee up the left side of the screen. Repeat that motion up the right side of the screen. Finally, use your thumbs to smooth the InvisibleShield along the edges of your screen. 1 2 3 4 5