JPT Skylake (H-110) Update BIOS+ME SOP 1. Please check the EFI folder is setting the same as below picture. (Disk\Removable disk\EFI\BOOT\) 2. Please check the ME_UPDATE place is Disabled(as below picture). 3. Booting to EFI shell mode. (How to enter the prompt command that please key-in FS0: (have non HDD device) or FS1: (have the HDD device).
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
JPT Skylake (H-110) Update BIOS+ME SOP 1. Please check the EFI folder is setting the same as below picture.
(Disk\Removable disk\EFI\BOOT\)
2. Please check the ME_UPDATE place is Disabled(as below picture).
3. Booting to EFI shell mode.
(How to enter the prompt command that please key-in FS0: (have non HDD
device) or FS1: (have the HDD device).
4. Go to the JPT H-110 BIOS folder and key in the update BIOS command
**(FPT.EFI –F XXXXX.ROM) as below picture.
**(FPT.EFI –F XXXXX.ROM -BIOS)
(The “-BIOS” command isn’t included the ME firmware update)
5. After finished, please remove AC power directly.
6. Please remove the ME_UPDATE jumper.
7. Wait 5 seconds, Insert AC power again and then power on the unit.