109 Conner Drive, Suite 2105 Chapel Hill, North Carolina 27514 • 919 967-6460 • 800-326-6460 • 919 967-8146 Fax • www.ocutech.com NOTE: If the top of the bridge is low the telescope eyepiece will not posion in the biopc posion at the top of the frame and may be out of posion for proper use. The SightScope® Paent Clip System works well on the Ocutech “K” and “Unisex” frames. Ocutech® frames can be ordered separately and the paent can use them as their standard eyeglasses with or without the SightScope® System aached. S TEP 1: Posion the top of the clip over the bridge of the frame. The clip contains a rubber spacer which will firmly catch the top of the bridge on metal frames. For plasc frames, simply remove the rubber spacer. S TEP 2: While holding the top of the clip in posion (centered over the bridge), spread the metal spring clip downward to catch the lower part of the eyeglass frame, and then repeat for the other side. If the clip is too loose, you can bend the spring wire upward to ghten its hold before aaching it to the boom of the frame. Spring clip to hold System in place Rubber spacer for metal frames (remove for plasc frames). 109 Conner Drive, Suite 2105 Chapel Hill, North Carolina 27514 • 919 967-6460 • 800-326-6460 • 919 967-8146 Fax • www.ocutech.com FLIP-UP B INOCULAR T ELESCOPE S YSTEM SightScope® FLIP Paent Clip-On System Ocutech’s SightScope® FLIP is available in a clip-on version that can be mounted on appropriate paent frames in lieu of ordering a complete frame and telescope system. The mounng system allows for the full range of posioning control that is available with the standard permanent eyeglass frame-mounted system. The SightScope® Paent Clip System can be used with both metal and plasc frames that have a high top bridge posion and are deep enough in the vercal dimension (B dimension) to allow the spring clip to hold the device firmly in place.