Page 1 of 7 - Please refer to your vehicle manufacturers handbook for maximum roof load capacity. - Any load transported on Roof Racks must be evenly distributed. - Do not attempt to fit the roof racks to your vehicle unless you fully read and understand the fitting instructions provided. - Please direct any questions to the dealer from where the roof racks were purchased. - Check the contents of kit before commencing fitment and report any discrepancies. ! ! ! ü km/h WARNING! ? kg 2 x Crossbars = 5kg
7
Embed
Fitting Instructions for Rhino Track Mount - Jeep Wrangler ...Fitting Instructions, Rhino Track Mount, Jeep Wrangler JK MY11 Hardtop, RTC8JWMY11, 2 door, RTC12JWMY11, 4 door Created
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Page 1 of 7
- Please refer to your vehicle manufacturers handbook for maximum roof load capacity.
- Any load transported on Roof Racks must be evenly distributed.
Roof racks must be removed when putting vehicle through an automatic car wash.Caution:Thehandling characteristicsof the vehicle changeswhenyou transport a loadon the roof. For safety reasonswerecommendyouexerciseextremecarewhentransportingwind-resistantloads.Specialconsiderationmustbetakenintoaccountwhencorneringandbraking.
Note for Dealers and Fitters:Itisyourresponsibilitytoensurethesefittinginstructionsaregiventotheenduserorclient.Placetheseinstructionsinthevehicle’sgloveboxafterinstallationiscomplete.
Rhino-Rack3PikeStreet,Rydalmere, DocumentNo:R194NSW2116,Australia. PreparedBy:CraigJones IssueNo:01(Ph)(02)96384744 AuthorisedBy:ChrisMurty IssueDate:27/04/2012(Fax)(02)96384822These instructions remain the property of Rhino-Rack Australia Pty. Ltd. andmaynotbeusedorchangedforanyotherpurposethan intended.
Page 2 of 7
Jeep Wrangler JK MY11 hardtop
Rhino Track Mount - Jeep Wrangler JK MY11 HardtopRTC8JWMY11 (2 door). RTC12JWMY11 (4 door)
Track positioning.Edgeoftrackcanbeusedtomarkastraightline.a. Measure 24mmfromtangentofhardtopradiusfrontandrear.Markdrillingcentreline.b. Frontoftrack.Measure160mm from front where the rubber seal meets.
Track positioning.Edgeoftrackcanbeusedtomarkastraightline.a. Measure 16mmfromtangentofhardtopradiusatfront,frontedgeoftrackhangsoveroninsidealittle. Measure 26mmfromtangentofhardtopradiusatrear.Markdrillingcentreline.b. Frontoftrack.Measure140mm from front where the rubber seal meets.
Fasten Track. Fingertightenallsquareheadboltstolocatethetrack.Onceallthreadshaveengagedstarttighteningfromthe centre and work towards the ends. DO NOT OVER TIGHTEN.
12
1
135
2
2 4 6
3 4Tighten knobs in order shown
(2 dr)
Tighten knobs in order shown
(4 dr)
End caps.Insert end caps into each end of the track.