Your Trusted Construction Partner Easy Fix Skim Coat Finish Coat Polymer Modified Cementitious Plaster Description Easy Fix Skim Coat is cement based on finish skim coat formulated to provide high quality smooth surface finish. Suitable for concrete /cement panel, aerated light weight block and skim plastered surface. Easy Fix Skim Coat is supplied as a ready to use blend of dry powder which requires only the site addion of clean water to produce a highly consistent cemenous skimming mortar. The material is based on a blend of cements, graded aggregates, special fillers and chemical addives to provide the material with good handling characterisc. Easy Fix Skim Coat has been tested by SIRIM BHD, in accordance to ETRC 257/16/1045 (R050/12), on Material Safety Data Sheet for physical properes. Uses Easy Fix Skim Coat is designed for use as a skim finish that provides a smooth, seamless finish for walls and ceilings. It is widely used in today Hotel, condominium, Bungalow, Luxury Apartment and detached houses etc. Advantages • High heat resistance • Fast Drying • Versale to use • Easy to use- good workability • Excellent adhesion to the concrete substrate • No cracking • Smooth interior and crack bridging ability • No primer and curing require • Non-asbestos • Smooth and superior finish • Non-combusble Standard Compliance • ETRC 257/16/1045 (R050/12) • BS EN 998-1 : 2003 Physical Properties MSDS Non toxicity in physical form Compressive Strength (BS EN 998-1:2003) > 5.0 N/mm 2 Flexural Strength (BS EN 998-1:2003) > 1.0 MPa Appearance Clean white/grey powder Density 1.20 – 1.30 g/ml Bond Strength 0.5 N/mm 2 Odour Odourless Cracking No cracking Application Instructions Surface Preparaon Ensure the surfaces must be clean, dry, and free of oil, grease, dust and loose parcles. For dry or high absorbing substrates, moisten the surface with water prior to applicaon. Mixing Easy Fix Skim Coat should be mixed in accordance to recommend mixing water unl a smooth, creamy, lump free consistency is obtained. Mixing water is approx 7.00 – 8.00 litres per one bag (25 kg). Mix with mechanical mixer for at least 3 to 5 minutes. Applicaon Apply the product paste at a thickness of approximately 1mm using a steel trowel. It should apply with minimum of working and trowel to an even and smooth surface. The thin films to dry for 5 to 30 minutes (depending upon the substrate porosity, temperature and humidity). The surfaces are joined with a firm pressure for at few seconds. Ensure the assembly not to trap any air. Prolonged pressure is not necessary. On very absorbing surfaces it can be necessary to apply the adhesive twice.