Field-IQ System Boom Height Control. Benefits Maintain boom height in uneven terrain Reduce operator fatigue Consistent spray tip height reduces.

Field-IQ SystemBoom Height Control

Benefits

Maintain boom height in uneven terrain Reduce operator fatigue Consistent spray tip height reduces drift

Four sprayer interface kits released Additional kits targeted 2007-2011 Rogator 2012-2013 Rogator RG series kit “Requires FIQ”

Case SPX 2009 and newer Miller 4000 and 5000 series New Holland SP.xxxF Apache series, 2009 and newer

Supported Models

Main differences in platforms are cables, hose length, hydraulic fittings, and brackets.

With FIQ installed a SIM module is already installed for manual control of switches in cab.

Cab kit What to order depends if Field-IQ is already installed

or not. Platform kit

Select appropriate make/model Hose kit

Select kit to match platform make/model kit Sensor kit

3 or 5 sensors available dependent on boom width Passcode for CFX-750 4.0

Optional center section upgrade kit

System Components

Valve Block Specific to Platform

Ordered to control boom wings

Upgraded to control center section

VM 430 Valve Module

Can command three valves

Same module used for Field Level II

SS-100 Ultra Sonic Sensor

Installed as a daisy chain between sensors

Must use terminators at the ends

Vibration and shock tolerant

Emergency Stop Button

Disable all booms with button before transporting or folding

1. Press Emergency Stop

2. Close field

3. Fold booms

Help eliminate possibility of the booms activating while in the hangers

Installation

Key Points of Installation

Determine location of sensors Consider placement when

folding booms

Key Points of Installation

Install instructions will give suggested mounting locations

Key Points of Installation

Sensor needs minimum 24” (60cm) from crop canopy or ground depending on mode of operation

Key Points of Installation

Ensure sensor bracket does not hang below bottom of boom and drag

Communication

Sensor computes distance Sends reading to CFX

CFX contains control algorithms

VM 430 receives digital command Sends analog command to valve

Height Sensor

Valve Block

VM 430 Module

Boom Status

Grey = disabled Yellow = enabled Green = engaged

Run Screen Icon Definitions

Setting Up Boom Height Control

Setup

Setting Up Height Sensors

Boom size determines placement of sensors Should be same height across boom

Setting Up Height Sensors

Enter distance from the sensor to spray tip to lower edge of sensor cone

Operation Setup

Operation Setup

Operation Setup

Adjust only if boom consistently lowers too fast

Operation Setup

Raise setting to reduce rocking

Depends on type of boom suspension

Operation Setup

This is your on target indication scale

Operation Setup

Maximum distance tip to target

Operation Setup

Minimum distance tip to target

Operation Setup

Amount increased or decreased when adjusting the Target Height

Operation Setup

Similar to Autopilot on line aggressiveness

Influenced by ground conditions

Installation Verification

After installation Manually verify

connections and hydraulics

Similar to Autopilot

Calibration

Have the center boom in a lower state and all booms level

Advanced Tab Features

Allows changes to setup wizard and advanced system changes

Importance of Signal Input Module

Using In Cab Controls

Additional Advanced Features

Diagnostics of Hardware

Operation

To enable a zone, select it individually To enable all zones, select center Enable All Only available when system is not engaged and all zones

are disabled

Operation

Buttons turn yellow when section enabled

Operation

To Disengage sections, tap each one individually or tap engage button to disengage all.

Operation

Arrow indicates direction zone being commanded to reach the Target Height

Run Screen Controls

Adjust Target Height - tap increase or decrease arrow Adjust Aggressiveness - tap increase or decrease arrow To set Target Height to the current height - tap Set to Current

button

Questions??