Installation Instructions 860648837 Rev A TC-40163-IP-EN Rev. A March 2019 Visit our website or contact your local CommScope ® representative for more information. www.commscope.com All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. © 2019 CommScope, Inc. All Rights Reserved This product may be covered by one or more U.S. patents or their foreign equivalents. For patents, see www.cs-pat.com For technical assistance, customer service, or to report any missing/damaged parts, visit us at: http://www.commscope.com/SupportCenter For optimal jumper management and ease of installation, color code labels can be placed on the side of the FACT-trumpets. The color coding will work in combination with the FACT FRAME color label on the frame backside and on the frame drums. 1. Select the color code based on the color selection table. Color selection is defined by the mounting position in the frame. 2. Place the color code label on the side of the trumpet on the FACT- element. 3. Check correct label placement: colors on FACT trumpets should match the color coding on the frame back plate. Numbering labels can be placed on the frontside of FACT-elements. Location and sequence can be defined by the customer. 8 FACT-elements color coded “A” 8 FACT-elements color coded “B” 8 FACT-elements color coded “D” 8 FACT-elements color coded “E” 8 FACT-elements color coded “F” 8 FACT-elements color coded “G” 8 FACT-elements color coded “C” color selection table Color Code Labels: Page 1 of 2 FACT Trumpet Color Coding - FACT FRAME a1 a1 a7 a2 a3 a4 a5 a6 a7 to Numbering Labels: b1