Ideal for heavy cutting applications Built in 3 piece Hirth coupling, faceplate does not lift during rotation Extremely accurate and repeatable Can be connected to machine’s control or run with a stand-alone control. Face Gear Indexers Item/Model No. Diameter of Table mm / inch Ø250 / 9.84” Ø320 / 12.59” Ø400 / 15.74” Ø500 / 19.68” Ø30 / 1.18” Ø60 / 2.36” Ø60 / 2.36” Ø130 / 5.11” Diameter of Thru-hole mm / inch Center Height in Vertical mm / inch 185 / 7.28” 210 / 8.27” 250 / 9.84” 310 / 12.20” mm / inch 315 / 12.40” 380 / 14.96” 460 / 18.11” 570 / 22.44” mm / inch 200 / 7.87” 240 / 9.45” 240 / 9.45” 310 / 12.20” mm 12 H7 14 H7 14 H7 mm 18 h7 18 h7 18 h7 18 h7 18 h7 FANUC α8i α12i HF-203 HF-203 HF-353 α12i α22i MITSUBISHI HF-153 SIEMENS 1FK7063 1FK7083 1FK7083 1FK7101 HEIDENHAIN QSY116J QSY155B QSY155B QSY155D 1:90 1:180 1:72 5° N/A N/A 1° 1° 1° 27.7 27.7 22.2 11.1 1:72 Degree 72D 360D Bidirectional Vertical RPM kgf•m / ft•lb 3000 / 6614 3500 / 7716 4300 / 9480 6100 / 13,448 sec. 10” 3” 130 / 287 250 / 552 330 / 728 550 / 1213 3” 3” 3” 10” 10” 10” kg / lbs 125 / 276 200 / 441 350 / 772 450 / 992 kg / lbs Horizontal 300 / 662 400 / 882 600 / 1323 800 / 1763 kg / lbs F (Axial Force) 3500 / 7716 4500 / 9920 6000 / 13,227 7000 / 15,432 kg / lbs FxL (Radial Moment) FxL (Tilting Moment) 200 / 1446 380 / 2748 550 / 3978 830 / 6003 kgf•m / ft•lb 275 / 1989 500 / 3616 770 / 5569 1160 / 8390 kgf•m / ft•lb 90 / 651 156 / 1128 320 / 2314 460 / 3327 kgf•m / ft•lb Overall Height in Vertical Overall Height in Horizontal Width of T Slot Width of Guide Block Servo Motor Type Total Reduction Ratio Minimum Increment Maximum Rotation Speed (Motor:2000 RPM) Clamping Capacity (Hydraulic System:35kg/cm2) Indexing Acurracy Repeatability Accuracy N.W. MAX. Work Load MAX. Thrust Load Driving Torque DC-250R DC-320R DC-400R DC-500R Fax: 513.701.5551 [email protected] Phone: 513.770.4200 www.CNCIndexing.com