Electron Configuration! Chapter 5
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Electron Configuration!Chapter 5
Helpful Videos
https://www.youtube.com/watch?v=J-DjEIlynjE
Quantum Mechanics
● Better than any previous model, quantum mechanics does explain how the atom behaves.
● Quantum mechanics treats electrons not as particles, but more as waves (like light waves) which can gain or lose energy.
● But they can’t gain or lose just any amount of energy. They gain or lose a “quantum” of energy.
A quantum is just an amount of energy that the electron needs to gain (or lose) to move to the next energy level.In this case it is losing the energy and dropping a level.
Atomic Orbitals
● Much like the Bohr model, the energy levels in quantum mechanics describe locations where you are likely to find an electron.
● Remember that orbitals are “geometric shapes” around the nucleus where electrons are found.
● Quantum mechanics calculates the probabilities where you are “likely” to find electrons.
Atomic Orbitals
● Of course, you could find an electron anywhere if you looked hard enough.
● So scientists agreed to limit these calculations to locations where there was at least a 90% chance of finding an electron.
Think of orbitals as sort of a "border” for spaces around the nucleus inside which electrons are allowed. No more than 2 electrons can ever be in 1 orbital. The
orbital just defines an “area” where you can find an electron.
Energy Levels
Quantum mechanics has a principal quantum number. It is represented by a little n. It represents the “energy level”.
● n=1 describes the first energy level● n=2 describes the second energy level… etc.
Each energy level represents a period or row on the periodic table.
Red n = 1Orange n = 2Yellow n = 3Green n = 4Blue n = 5Indigo n = 6Violet n = 7
Sub-levels = Specific Atomic Orbitals
Each energy level has 1 or more “sub-levels” which describe the specific “atomic orbitals” for that level.
● n = 1 has 1 sub-level (the s orbital)● n = 2 has 2 sub-levels (s & p)● n = 3 has 3 sub-levels (s, p, & d)● n = 4 has 4 sub-levels (s, p, d & f)
There are 4 types of atomic orbitals:● s, p, d and f● Each of these sub-levels represent the
blocks on the periodic table.
Blue = s blockYellow = p blockRed = d blockGreen = f block
Orbitals
● In the s block, electrons are going into s orbitals.
● In the p block, the s orbitals are full. New electrons are going into the p orbitals.
● In the d block, the s and p orbitals are full. New electrons are going into the d orbitals.
s p
d
● Complete the chart in your notes as we discuss this.
● The first level (n=1) has an s orbital. It has only 1. There are no other orbitals in the first energy level.
● We call this orbital the 1s orbital.
Energy Level
Sub-levels Total Orbitals Total Electrons
Total Electrons per Level
n = 1 s 1 (1s orbital) 2 2
n = 2 sp
1 (2s orbital)3 (2p orbitals)
26
8
n = 3 spd
1 (3s orbital)3 (3p orbitals)5 (3d orbitals)
2610
18
n = 4 spdf
1 (4s orbital)3 (4p orbitals)5 (4d orbitals)7 (4f orbitals)
261014
32
Where are these Orbitals?
1s
2s
3s
4s
5s
6s
7s
3d
7p
6p
5p
4p
3p
2p
5f
4f
6d
5d
4d
Electron Configurations
What do I mean by “electron configuration?”
●The electron configuration is the specific way in which the atomic orbitals are filled.
●Think of it as being similar to your address. The electron configuration tells me where all the electrons “live.”
Rules for Electron Configurations
3 rules govern electron configurations:● Aufbau Principle● Pauli Exclusion Principle● Hund’s Rule
Using the orbital filling diagram at the right will help you figure out HOW to write them
● Start with the 1s orbital. Fill each orbital completely and then go to the next one, until all of the elements have been accounted for.
Fill Lower Energy Orbitals FIRST
● The Aufbau Principle states that electrons enter the lowest energy orbitals first.
● The lower the principal quantum number (n) the lower the energy.
● Within an energy level, s orbitals are the lowest energy, followed by p, d and then f. F orbitals are the highest energy for that level.
Each line represents an orbital.
1 (s), 3 (p), 5 (d), 7 (f)
Low Energy
High Energy
Write the electron config. below for each of these elements:
Sodium:
Iron:
Bromine:
Barium:
Write the electron config. below for each of these elements:
Sodium: 1s22s22p63s1
Iron: 1s22s22p63s23p64s23d6
Bromine: 1s22s22p63s23p64s23d104p5
Barium: 1s22s22p63s23p64s23d64p65s24d105p66s2
No more than 2 Electrons in Any Orbital…ever
● The next rule is the Pauli Exclusion Principal.
● The Pauli Exclusion Principle states that an atomic orbital may have up to 2 electrons and then it is full.
● The spins have to be paired.
● We usually represent this with an up arrow and a down arrow.
● Since there is only 1 s orbital per energy level, only 2 electrons fill that orbital.
Quantum numbers describe an electrons position, and no 2 electrons can have the exact same quantum numbers. Because of that, electrons must have opposite spins from each other in order to “share” the same orbital.
Hund’s Rule
● Hund’s Rule states that when you get to degenerate orbitals, you fill them all half way first, and then you start pairing up the electrons.
● What are degenerate orbitals?● Degenerate means they have the
same energy.
Don’t pair up the 2p electrons until all 3 orbitals are half full.
Let’s try it out!
● NOW that we know the rules, we can try to write some electron configurations.
● Lets write some electron configurations for the first few elements, and let’s start with hydrogen.
Electron Configurations
Element Configuration Element ConfigurationH Z=1 1s1 He Z=2 1s2
Li Z=3 1s22s1 Be Z=4 1s22s2
B Z=5 1s22s22p1 C Z=6 1s22s22p2
N Z=7 1s22s22p3 O Z=8 1s22s22p4
F Z=9 1s22s22p5 Ne Z=10 1s22s22p6
(2p is now full)Na Z=11 1s22s22p63s1 Cl Z=17 1s22s22p63s23p5
K Z=19 1s22s22p63s23p64s1 Sc Z=21 1s22s22p63s23p64s23d1
Fe Z=26 1s22s22p63s23p64s23d6 Br Z=35 1s22s22p63s23p64s23d104p5
Note that all the numbers in the electron configuration add up to the atomic number for that element. Ex: for Ne (Z=10), 2+2+6 = 10
● One last thing. Look at the previous slide and look at just hydrogen, lithium, sodium and potassium.
● Notice their electron configurations. Do you see any similarities?
● Since H and Li and Na and K are all in Group 1A, they all have a similar ending. (s1)
Electron Configurations
Element ConfigurationH Z=1 1s1
Li Z=3 1s22s1
Na Z=11 1s22s22p63s1
K Z=19 1s22s22p63s23p64s1
●This similar configuration causes them to behave the same chemically.●It’s for that reason they are in the same family or group on the periodic table.●Each group will have the same ending configuration, in this case something that ends in s1.
The End
Related Documents
