EKB500 UPGRADE MANUAL

EKB500 UPGRADE MANUAL

Material

1. PC2. EKB5003. RS232 cable4. Firmware files

System connection

EKB500 PC

RS232 cable

Connect RS232 cable to EKB500

Back panel of EKB500

RS232 cable

Connect RS232 cable to PC

Back panel of PC

RS232 cable

Upgrade step 1

1. Connect EKB500 and PC with RS232 cable

2. Turn on EKB500

3. Press SHIFT+MENU to enter keyboard setting

4. Choose “Keyboard Setting” -> ”Firmware update”, then input 123 and press ENTER key to confirm.

5. You will see that LCD on EKB500 shows Enter ISP modeNow…

Upgrade step 2

1. Please check which com port of your PC is connected to EKB500.

2. Unzip upgrade file in your PC, you can find six BAT files in the folder.

3. Execute the BAT file that matches the number of com port. EX: If RS232 cable is connected to com port 3, please execute “burn_com3.bat” Please refer pictures in next two pages to determine whether upgrade process is executing or not.

4. When upgrade process completes, EKB500 will reboot automatically Warring: Please don’t disconnect RS232 cable or turn off EKB500

when upgrading process is executing, or EKB500 will break.

If you can see this screen, it means that upgrade process is executing. Please wait, and don’t do anything until process completes.

Process is executing

If upgrade process hold in synchronizing, it means that the connection fails.

Please check that:1. LCD on EKB500 shows “Enter ISP mode Now…”2. IF the process you execute matches to the number of com port that

is connected to EKB500.

Connection fails