4.CERAMIC HEAD WORK 1. AERATOR 2. FILTER 5. BOLT 6. BOLT 3.NUT SPECIFICATIONS OPERATING CONDITIONS S06219S TROUBLESHOOTING "EGO" THERMOSTAT BATH & SHOWER SET TX449SE TX449SEN "EGO" Thermostat Bath & Shower Set INSTALLATION MOUNT CONNECTORS PARALLEL WITH THE WALL 1 3 5 A0905 OPTIONAL SHOWER TYPE SHOWER D1205QMFT1 A0905 Cover Spout Filter Body CHECK POINT Flow rate unsatisfactory 1, 2 Remove and clean Water leaks around the handle Tighten PROBLEM SOLUTION Handle is loose 5, 6 Tighten 3, 4 Flexible Hose w/ Packing Screw Hanger Hand Shower 150±20 150 Hot Water Supply Cold Water Supply Leg 2 4 Adjust the number 40º on the handle with mark line in the body, then install the handle If get the water temperature at 40ºC, release the handle. Make sure the spindle not rotated. 6 40 Mark Line Handle Spindle Bolt Handle 40 o C Safety Knob Open full the stop valve and check the water temperature 40ºC. When water temperature not 40ºC , set the water temperature until get 40ºC then follow step 5 and 6. 2 X Ø8 Holes TX449SEV1N "EGO" Thermostat Bath & Shower Mixer w/o Hand Shower Set MAINTENANCE Always wipe chrome plated area with dry soft cloth, and sometimes wipe it with cloth soaked in mild soap. TX449SEV2Z "EGOII " Thermostat Bath & Shower Set _ MARK Sleeve Anchor 171 42° Ø8 20 40 55 47 Ø50 215.5 0 -7 PJ ½ 150±20 228 0 -7 D1205QMFT1 Cap ALIGN WITH MARK OPEN O-Ring R4 Bolt Washer Cap Washer ATTENTION 1. Use of abrasive cleaning material such as; detergents containing hydrochloric acids, thinner, polishing powder, and nylon brush is not recommended. 2. Press safety knob turn left to increase temperature over 40 o C. 3. Please don't open the thermostat cartridge, because it cause to unstabilize temperature in this product. 4. Flow Regulator should not be remove because it could damage the system 1. Water supply pressure : 0.05 ~ 0.75 MPa. Hot water supply temperature shall be higher by 10 o C. at least, than desired temperature of mixed water. (Recommendation: Hot water supply temperature =60 o C) Hot water supply pressure shall be the same or lower than cold water supply . Ensure that water supply is clean (No Sand, Dirt, Etc.). 2. 3. 4. Flow Regulator Inside (Don’t remove) Rain Spray Button Massage Spray Button