Mechanical Assembly Instruction List of components: 1. 2 x 2’ Aluminum Tracks w/ Three legs 2. 1 x 4’ Aluminum Tracks w/ 6 legs* (Note: This track can be separated into 2 x 2’ tracks by removing the center locking mechanism) 3. 4 Adjustable Billet Sensor assembly 4. 2 Die Sensor assembly 5. 4 x 100lb Strength Magnets 6. 1 x ‘3 Aluminum Track w/ 2 legs 7. 1 Mirror support/Sensor Fastener 8. 1 Vertical Mirror post 9. <Insert image of parts> Setup Instructions 1. First ensure the magnets are attached to the middle leg of the 2’ Aluminum Tracks to ensure secure locking between the shoe and the track. 2. Place tracks in desired location. Adjust tracks as necessary to be as parallel to the closest face of the die as possible. WARNING: Make sure you do not have part of your body under or near the magnet prior to placing on the shoe. Severe Injury can occur due to the high strength of the magnet attracted to the shoe.