BMED-4800/ECSE-4800 Introduction to Subsurface Imaging Systems Lecture 6: Nuclear Medicine Kai E. Thomenius 1 & Badri Roysam 2 1 Chief Technologist, Imaging Technologies, General Electric Global Research Center 2 Professor, Rensselaer Polytechnic Institute Center for Sub-Surface Imaging & Sensing
40
Embed
ECSE-4963 Introduction to Subsurface Sensing and Imaging Systems
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
BMED-4800/ECSE-4800Introduction to Subsurface
Imaging SystemsLecture 6: Nuclear Medicine
Kai E. Thomenius1 & Badri Roysam2
1Chief Technologist, Imaging Technologies, General Electric Global Research Center
2Professor, Rensselaer Polytechnic Institute
Center for Sub-Surface Imaging & Sensing
Homework #3:Using the “Faridana” (Adel Faridani) filtered back projection code example, change filter
parameters for a lower bandpass. Demonstrate loss of spatial resolution.• http://people.oregonstate.edu/~faridana/preprints/
preprints.html– A. Faridani: Introduction to the Mathematics of Computed
Tomography. Inside Out: Inverse Problems and Applications, G. Uhlmann (editor), MSRI Publications Vol. 47, Cambridge University Press, 2003, pp. 1-46.
• http://www.onid.orst.edu/~faridana/preprints/fbp.txt - MATLAB code for filtered back projection– Designer Shepp-Logan phantom– Filter design possibilities– Make sure to use the modified code (fbp2ket.m) available from
http://www.ecse.rpi.edu/censsis/SSI-Course
Recap: CT & Filtered BackprojectionBackprojection reconstructionw. no filtering.
Taking Stock of x-ray CT• X-ray images of a live or dead subject look the
same!– the core contrast mechanism does not depend on
activity, only on structure• Some activities can be sensed (e.g., gross movements can be sensed with cine x-ray)
–The kinds of activities with the greatest medical value are of a biochemical nature• They involve the presence/absence, chemical state, spatial distribution, and movements of specific biochemicals in the body
• This observation has driven the development of functional & molecular imaging methods.
Nuclear Medicine• Basic Idea:
– Inject patient with radio-isotope labeled substance (tracer)
• Chemically the same as a biochemical in the body, but physically different
– Detect the radioactive emissions (gamma rays)
• Super-short wavelength• But, can’t achieve the implied high
resolution– Detection technology limitations– Not enough photons!
– This can be done in 2D: scintigraphy– This can be done in 3D: SPECT/PET
• Use filtered back-projection to reconstruct the 3-D image, just like x-ray CT
Nuclear Medicine• Imaging is done by tracing the
distribution of radiopharmaceuticals within the body.
• Radionuclides or radioisotopes are atoms that undergo radioactive decay, and emit radiation.
• In nuclear medicine, we are interested in radionuclides that emit x-rays or gamma rays.
• A radiopharmaceutical is a radionuclide bound to a biological agent.
Example: FDG• Fluorodeoxyglucose is a
radiopharmaceutical is a glucose analog with the radioactive isotope Fluorine-18 in place of OH
• 18F has a half life of 110 minutes• FDG is taken up by high glucose using
cells such as brain, kidney, and cancer cells.
• Once absorbed, it undergoes a biochemical reaction whose products cannot be further metabolized, and are retained in cells.
• After decay, the 18F atom becomes a harmless non-radioactive heavy oxygen 18O– that joins up with a hydrogen atom, and forms glucose phosphate that is eliminated via carbon dioxide and water
2-Deoxy-D-Glucose (2DG)
What Happens Upon Radioactive DecayBasic Idea:
– Nucleus emits a positron (an anti-electron)• A short-lived particle• Same mass as electron, but
opposite charge– Positron collides with a
nearby electron and annihilates• Two 511 keV gamma rays
– Compton Scatter (lose energy to an electron, and creat e alower-energy photon). For 100KeV – 10MeV
– Electron-positron pair Production (For > 1MeV)
• Any one of these can happen to the radionuclide gamma-rays.
Compton Scatter
Pair Production
Energy of a Gamma Ray• A radionuclide has a
typical energy: e.g. 140 keV for 99mTc
• Detection of lower energy scattered gamma- or x-rays degrades contrast and image quality.
• A radioisotope emits one (or more) very sharp energy lines
Effects of Gamma Rays on Tissue
• Gamma rays cause ionization–Capable of causing damage at the
cellular level• Actually used to ultra-sterilize equipment• Used to kill tumors (radiation therapy)
– The greatest damage occurs in the 3 – 10MeV range
–High energy gamma rays just pass throuigh the body and cause no damage
How do we Detect Gamma Rays?• Some crystals (sodium iodide) exhibit the property of scintillation. • Scintillation is a flash of light produced in a transparent material by
an ionization event. • When a gamma ray strikes this crystal, it knocks an electron loose
from an Iodine atom. • This electron then goes to a lower energy state, and in doing so,
emits a faint burst if light• This faint burst of light can be detected using a sensitive device
known as a photomultiplier tube (PMT).• Electronic circuits count the number of flashes and these numbers
are used to reconstruct images.
Cross-section of an Anger Camera
1. Shield Around Head 2. Mounting Ring 3. Collimator Core 4. Sodium Iodide Crystal 5. Photomultiplier Tubes
Named after Hal Anger
Cross-section of an Anger Camera
Collimator Design & Function
Resolution v. Efficiency Trade-off
SPECT Instrument• The “gamma camera” is a 2-D array
of detectors• One or more gamma cameras are
used to capture 2-D projections at multiple angles
• Use filtered back-projection to reconstruct 3-D image!
– Actual sinograms appear “noisy” due to the fact that we don’t have enough photons
– Quantum-limited imaging
3-camera SPECT instrument
Modern SPECT Scanners
• GE Hawkeye DigiRad Mobile SPECT System
Nuclear Medicine Images• Typical image:
– 64 by 64 pixels
• Intensity gives “counts per pixel”
• Pseudocolor often used.• Nuclear med imaging
modes:– Static– Dynamic– MUGA– Whole Body– SPECT
Whole Body Imaging
• Bright spots indicate regions where the radioisotope is bound
Cardiac Study
Cardiac Study• Evaluation of the
coronary artery circulation– Myocardial
perfusion• 3D Studies of the
radionuclide activity
Nuclear Medicine Performance Metrics
• Typical performance:– Energy resolution: 9.5 – 10%
– quick acquisition and simple reconstruction– Can be made nearly portable – Can be shaped to suit custom applications– Can be made to acquire time series– Can be gated to sync with other signals (e.g., ECG)– Multiple camera heads (typ. 2 – 3) can speed up acquisition
• Main Weakness:– Low resolution: Reconstructed images typically have resolutions of
64×64 or 128×128 pixels, with the pixel sizes ranging from 3–6 mm.)
– Attenuation of gamma rays leads to underestimation of activity in deep regions
– Intense areas of activity result in a lot of “streaking” artifacts
Ways to Improve Upon SPECT• Better reconstruction algorithms
– Model the point spread of photons more accurately– Model the non-uniform attenuation of gamma rays in
the body (leveraging x-ray CT)• Build combo “x-ray CT & SPECT” systems
• Use both the photons: PET– Since a pair of gamma rays at 180o are produced, try
to detect pairs of photons instead of single photons• Detect photon timing: TOF-PET
– The difference in photon arrivals can tell us where the decay event occurred!
Better Algorithms
• Filtered back-projection algorithm – produces a background
artifact, discussed earlier– Noisy reconstruction
• The Maximum Likelihood algorithm produces a better reconstruction for the same data
Filtered Back-Projection
Maximum Likelihood
Positron Emission Tomography: PET
• Several gamma-detector rings surround the patient.• When one of these detects a photon, a detector opposite to it, looks for a
match.• Time window for the search is few nanosecs.• If such a coincidence is detected, a line is drawn between the detectors.• When done, there will be areas of overlapping lines indicating regions of
radioactivity.
Emission Detection
• If detectors A & B receive gamma rays at the approx. same time, we have a detection
• Hard sensor and electronics design problem, expensive
A
B
Ring of detectors
Image Reconstruction
• We can sort our set of detections by angle, and view the data as a set of angular projections
• Use filtered back-projection algorithm!
PET Images
• Single-channel images• Noisy, and blurry
– Not ideal for segmentation– Segment MRI/CT for defining
anatomy– Register the images– Measure activity
PET Radiotracers
• 18FDG is probably the most widely used PET tracer.
• HIGH FDG pick-up by tumors first reported in 1980 at Brookhaven NL.
• Can also be used to measure rate of metabolism in the brain.
Application in Lung CancerCase Study:•55-year old female
•Lung Cancer•2 cycles of chemo & radiotherapy
PET results:•Increased uptake of FDG in lung nodules
•Increased uptake of FDG in lymph nodesTherapy will have to be continued.
SPECT vs PET
• Both are Major Functional imaging tools– SPECT: Single-photon Emission Computed Tomography
• cheap and low-resolution• Tells us where blood is flowing
– PET: Positron Emission Tomography• expensive but higher-resolution
PET image Showing a tumor
How Does PET Compare With Other Imaging Modalities?
• PET provides images of molecular-level physiological function
• Extends capabilities of other modalities.– Like MR & CT, it uses tomographic algorithms– Like Nuclear Medicine, the images represent distributions of
radiotracers.• But that’s where the similarity ends…
CT Scan MRI Scan PET Scan
Report: Normal Report: Normal Report: PatientDeceased.