EC15B - Maskinisten · Hydraulic system Additional double-acting hydraulic control valve for an attachment circuit with folding control pedal and circuit for direct return of oil

This technical specification sheet is intended to be used as aguide only.

All measurements and dimensions have been provided by therespective manufacturers, however please note that in mostcases the dimensions apply to base models.

Vehicles provided by Fork Rent often benefit from having aspecification far in advance of the base model and this mayaffect the final dimensions of the vehicle.

If dimensions are critical please seek further clarification from amember of the Fork Rent Sales Team on 01473 727674.

• Gross Power :14 kW / 19 ch

• Net Power :ISO 9249 : 11.3 kW / 15.5 ch

• Operating Weight :1479 - 1478 kg

• Bucket Capacities :16 - 60 l.

• Maximum Digging Depth :2200 - 2520 mm

• Load Sensing Hydraulic Systemfor very precise controls under allload conditions.

• Simultaneous diggingmovements and high speedoperations for faster cycle timesand increased productivity.

• ROPS, TOPS and FOPS cab and canopy for a better operator safety.

• Compact dimensions. Wrap-around counterweightprotects the rear compartmentagainst all impacts.

• Excellent serviceability thanks toeasy access to the engine andhydraulics compartments.

EC15BVOLVO COMPACT EXCAVATOR

EC15B

XR

Operating mass and groundpressure

Canopy version

Cab version

RubberTracks

1479 kg0.28 kg/cm2

1603 kg0.30 kg/cm2

Transport mass (according to standard ISO 6016)

Canopy version

Cab version

RubberTracks

1354 kg

1478 kg

UNDERCARRIAGEENGINE

HYDRAULIC SYSTEM

ELECTRICAL SYSTEM

BUCKET PERFORMANCE

WEIGHT

SERVICE FILL CAPACITIES

DRIVETRAIN

Rated voltage .................................................................................... 12 VBattery capacity .................................................................. 12 V - 45 AhAlternator rating .................................................................... 12 V - 40 AStarter motor output ........................................................ 12 V - 1.6 kW

Closed-centre Load-Sensing hydraulic system providing totalindependence of each movement.

Control ............................................ power-assisted hydraulic controls

Gear pump for all the equipment, travel and power-assistancecircuits:

Maximum delivery .............................................................. 32 litres /min.Maximum operating pressure .............................. 17 MPa (170 bars)

Double-acting hydraulic circuit for accessories:

Maximum delivery .............................................................. 32 litres /min.Maximum operating pressure .............................. 17 MPa (170 bars)

Cushions:

On the boom ram ............................................................ at the rod end

Breakout force ........................................................................ 1510 daN Tearout force .............................................................................. 960 daN

SLEWING SYSTEM

Turntable slewing is provided by an Ortitrol hydraulic motorwhich drives directly (without a reduction gear) a ball internalcrown wheel with remote lubrication :

Slewing speed .............................................................................. 9 r/min

Overall widths ............................................................................ 980 mm*Track width .................................................................................. 230 mmTrack tension ................................................................ by grease pistonBlade height ................................................................................ 240 mmTrack blade width ...................................................................... 980 mm

* A 1200 mm wide chassis is avaible as an option.

Each track is driven by an Orbitrol hydraulic motor.

Max. speed .................................................................................. 2.0 km/h Max. tractive force .................................................................. 1260 daN

Fuel tank .............................................................................................. 21 lHydraulic system, total ...................................................................... 33 lEngine oil ............................................................................................ 3.6 lCooling system .................................................................................. 4.5 l

NOISE LEVELS

Results of dynamic measurements :

Noise level exterior (LwA) ........................................................ 92 dB(A)Noise level in the cab (LpA) .................................................... 78 dB(A)Noise level under the canopy (LpA) ...................................... 77 dB(A)

Exterior sound level guaranteed according to the new regulation2000/14/CE.

Water-cooled low emissions Mitsubishi L3E diesel engine.

Displacement, total ...................................................................... 952 ccGross power, rated ...................... 14.0 kW (19.0 hp) at 2800 r/min Power, installed (ISO 9249) ...... 11.3 kW (15.5 hp) at 2200 r/minMaximum torque (ISO 9249) .............................. 54 Nm at 1850 rpmBore x stroke ................................................................ 76 mm x 70 mm

** Front turning circle with max. offset

S/T**

X

IJ

KM

PG

N

H

EC15B

DIMENSIONS

in mm

* Option : 1200 mm

E

F

A

B

C

D

EC15B

W

U/ V*

Q

R

L

540 mm

460 mm

1160 mm 80°

60°

980 mm

* Canopy

* Dig depth with blade down.

XR: Fixed undercarriage

240 230 450 1520 1230 2270 2210 970 1120

P Q R S T U V W X

210 150 1045 1415 860 980* 3650 1345

G H I J K L M N

3410 2480 2200 2050 1500 3570 3710

3550 2620 2450 2300 1740 3810 3940

3740 2710 2520 2380 1950 3980 4070

Dipper A B C* C D E F

1150 mm

Telescopic dipper

900 mmWidth Weight Capacity

250 mm 25 kg 19 l

300 mm 28 kg 24 l

350 mm 30 kg 28 l

400 mm 32 kg 33 l

450 mm 35 kg 38 l

500 mm 37 kg 43 l

600 mm 40 kg 53 l

850 mm 43 kg 52 l

1000 mm 47 kg 60 l

Buckets

Backhoebuckets

Ditch bucket

STANDARD EQUIPMENT

OPTIONAL EQUIPMENT

Cab (cab version)Level 1 FOPS (Falling ObjectsProtective Structure).TOPS (Tip-Over ProtectiveStructure).ROPS (Roll-Over ProtectiveStructure).Vinyl-covered multi-adjustablesprung seat.Non-slip floor and grab handlesfor access to the driver's cab.Seatbelt.Cab mounted on rubbermountings.Two working lights.Two-speed heating andventilation.Cab heat adjustment.Front window with openingsystem power-assisted by twogas rams.Sliding window (right).Door stops.Provision for a radio (location fora radio and two speakers, aerialand electric wiring already fitted).Interior lighting.Anti-corrosion protection of thecab.Windscreen wiper and washer(front).Emergency exit via the rear window.

Retractable seatbelt.Safety valve on boom and dipperram.Dual stage air filterAudible travel warning.Document storage.

MiscellaneousTool kit.Special customised paint (RAL specifications).

Engine Dry-type air filter.Electric pre-heating device.Transparent diesel oil filter, pre-filter and sediment bowl.Oil sump sheet metal guard.Hand throttle.

Electrical system12 V - 45 Ah maintenance-freebattery.Horn.12 V power socket for inspectionlamp.

Undercarriage230 mm wide rubber tracks.Dozer blade.Towing and anchoring points.Remote lubrication of the slewing crown ring.

Hydraulic systemAdditional double-actinghydraulic control valve for anattachment circuit with foldingcontrol pedal and circuit for directreturn of oil to the hydraulic tank.Attachment circuit piping(double-acting) as far as thebottom of the boom.Power-assisted control of thehydraulic offset of the boom bythe left control lever.Control of forward movement bytwo levers.Hydraulic oil cooler.

Canopy (Canopy version)Level 1 FOPS (Falling ObjectsProtective Structure).TOPS (Tip-Over ProtectiveStructure).ROPS (Roll-Over ProtectiveStructure).Vinyl-covered all weather multi-adjustable sprung seat.Non-slip floor and grab handle foraccess to the driver's cab.Seat belt.Working light on the canopy frame.

Instrumentation andmonitoringMonitoring and warning light for :pre-heating, engine oil pressure,water temperature, batterycharging, air filter restriction.Fuel gauge.Hour meter.Shut down for automatic switching off engine in the eventof overheating or drop in oilpressure.

Working equipment1750 mm long monobloc boom.900 mm dipper.140º hydraulic boom offset.Cushion on the boom ram.Handling equipment for loadsinferior to 1000 kg (lifting hookon the bucket with load chartdisplayed in the driver's cab).Remote lubrication of the bottomof the offset ram.

SafetyEngine safety start device : theleft console must be raised tooperate the starter.Nitrogen accumulator on thepower assistance circuit in orderto be able to put the equipmenton the ground if the engine isswitched off.Window-breaker hammer (cab).Key-lockable toolbox.

Official approvalMachine conforming to directivenº 98/37 EEC and itsamendments.Sources emissions in theenvironment conforming todirective 2000/14/CE.Handling device conforming toEN standard 474-5.FOPS 1 conforming toISO standard 3449.TOPS conforming toISO standard 12117.Electromagnetic compatibility(EMC) conforming to directivenº 89/336 EEC and itsamendments.

(opening/closing and rotation ofthe bucket).Push-pull connectors forattachment line.

UndercarriageWide chassis (width : 1200 mm).

LightingAdditional working light on theboom.Additional rear working light.Rotating beacon.

Environmental protection Bio-degradable hydraulic oil.Catalylic exhaust.

Comfort and safetyRadio (cab).Anti-theft system(2 programmable codes).Rear wind-deflector on canopy.Battery isolator switch.Fabric seat (cab).Translation pedals.

Under our policy of continuous product improvement, we reserve the right to change specifications and design without prior notice.The illustrations do not neccessarily show the standard version of the machine.

Volvo Construction Equipment Ref. No. 21 4 432 1100 English

Printed in PDF 2002.04Volvo, Belley CEX 2908158

Working equipmentLong dipper (1150 mm).Telescopic dipper 900-1225 mm.Mechanically-controlled quick-release attachment bracket.

Hydraulic circuits forattachmentsHydraulic circuit for single ordouble-acting attachments(Auger ...)Hydraulic circuit for operating aclam-shell bucket